Looking for some help

[freebird01]

Ok guys...I am kind of excited at the response for plasma cut parts. (we will see how it really goes if i get the system)

however to try to be a little bit proactive I am looking to you guys for help.

What I need:

NEW exhaust manifold gaskets , Intake Gaskets, and a lift pump gasket and any kind of turbo flange gaskets

I must have the fiber gaskets and not any metallic ones. I don't want to scratch the heck out of my scanner.

If you would like them back you just need to let me know. I'm sure we can work on some sort of compensation once i get things up and going.

PM me with questions and an address

 

[65sixbanger]

I have about three lift pump gaskets

 

[Agnem]

An intake gasket is a turkey pan. Good luck getting that in your scanner.

You'd be better off with an old one that somebody is going to trash. Then you could just cut off the intake runner portion.

 

[freebird01]

An intake gasket is a turkey pan. Good luck getting that in your scanner.

You'd be better off with an old one that somebody is going to trash. Then you could just cut off the intake runner portion.

you got an old one to donate to the cause oh great one of all that is burning of oil

 

[towcat]

i have an extra turkey pan as well as exhaust manifold gaskets. problem is both are metal. I've never seen non-metalic ones. I also have a frewall plate hacked out of a 86f250

 

[freebird01]

guess that would just mean i would have to lay them out by hand rather then scan and trace...i was hoping for non metallic. i know some of the gasser stuff you can get elcheapo fiber gaskets wasn't sure about the diesel stuff.

does this stuff interchange between the 6.9 and 7.3idi?

 

[Agnem]

Calvin, doesn't the turkey pan intake gasket portion have a fiber/paper coating on both sides?

 

[towcat]

Calvin, doesn't the turkey pan intake gasket portion have a fiber/paper coating on both sides?

not on the ones I've been pulling off. can post a pic later.

 

[jperecko]

If you are just using a regular scanner, just put some clean plastic between the glass and the part... food wrap of plexiglass etc.

 

[freebird01]

Bringing this back as I am trying to start developing some of my burn profiles while i get the business end of the company setup and i'm having to watch my 2yr old in the evenings...

still need gaskets for the idi stuff

 

[towcat]

any interest in a firewall plate too?
i know there's a market to reinforce the firewall from flexing

 

[freebird01]

any interest in a firewall plate too?
i know there's a market to reinforce the firewall from flexing

i sent ya a pm a while ago towcat