BigRedWeather
Full Access Member
I have my axle out and need to replace the seal. Looking at the pictures is this what I need to do to replace the seal?
-remove the nut with the special tool
-does that allow me to pull the whole end off and access the seal?
-replace the seal
-reassemble
-done?
-Any other special tools, special torque
Do I need to apply a lot of torque with the special tool in the picture, or could I make my own buy cutting a large socket and leaving four protrusions? Could I remove the nut if my self made tool didn't have the center guide that fits inside the hole the shaft came out of.
Thanks,
BigRedWeather
-remove the nut with the special tool
-does that allow me to pull the whole end off and access the seal?
-replace the seal
-reassemble
-done?
-Any other special tools, special torque
Do I need to apply a lot of torque with the special tool in the picture, or could I make my own buy cutting a large socket and leaving four protrusions? Could I remove the nut if my self made tool didn't have the center guide that fits inside the hole the shaft came out of.
Thanks,
BigRedWeather