the third gauge in my pod will be air pressure since i am going to put on board air on my truck. other than that if it was me i would put water temp on mine.
Went for the oil pressure since the other two are monitoring actions around the turbo.
Personally. I would grab the other 3 and go with an A-pillar 2 pod and a 3 cluster as all are good to have.....dang factory entertainment gauges.
I got tranny on my a-pillar w/ boost and egt. Water, Oil pressure and volts on top of the dash. Might add vacc. to my center console. gauges are like money, can't have too much!
I voted water temp because in my expeirence when pulling a trailer up a grade you need to keep an eye on this more so than oil pressure. If you start to loose oil your idiot moving gauge will tell you that (when the needle moves down you pull over) but with knowing water temp this as well well tell you when you need to back off a bit.
Voted water temp too. I really wouldn't trust any of the factory gauges; my oil press gauge read higher than normal with ~1 quart in the system, but you can TELL when you have too little oil pressure. If you listen. Water temp can be a little more difficult. Really should get both though
James
i didn't vote, 'cause my vote is "both" - water temp & oil pressure.
i say fab up a 4 gauge pod from 2 doubles... i can dig up pics from StopTheDrama where a guy did a really nice job. i think i have him saved in my PM box
Dog: shouldn't you be picking up those kids?
or were you just trying to get rid of me?
counting eric and ramon for water temp i get 13-10, water temp winning, slightly, not sure which way i'll go, i'd like to stick to 3 gauges for now but who knows.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.