GOT CAMBER/CASTER GUSHING KIT TODAY

[bagpiperjosh]

GOT CAMBER/CASTER BUSHING KIT TODAY

so I was just delivered the camber caster adj kit from napa, because my caster is way off....and they are these

http://www.napaonline.com/Catalog/CatalogItemDetail.aspx/Camber-Caster-Kit-Front-Susp/_/R-NCP2749148_0006542304


how and where do i install these? and what the heck is the little metal thing?

thanks

 

[bagpiperjosh]

are these even correct?

 

[bagpiperjosh]

no ball joints. its kingpins

 

[Dave Barbieri]

Yup, those are correct. Once installed, as you rotate them, the offset hole moves the radius arm up and down, which tilts your I-beam axle forward or backward.

 

[bagpiperjosh]

Yup, those are correct. Once installed, as you rotate them, the offset hole moves the radius arm up and down, which tilts your I-beam axle forward or backward.

ahh... i gotcha

 

[bagpiperjosh]

and *** is that metal thing?

 

[Dave Barbieri]

That's the locking tab. That sits between the adjustable bushing and the bracket attached to the frame. The long end bends forward over the bracket and the short end bends up on to the square side of the bushing. That way it stays where you set it.