texcl
Full Access Member
Also about tire noise, if your tire has bubbles chances are there is an underlying issue like bad ball joints bearings ect... so the new tire might quiet it down but in a couple thousand miles you might be buying new tires again.
here's a pic of my hub apart. see the giant socket you need for removal in the pic.
here's what one ujoint cap looked like when I took her down
the bare knuckle
this is that messed up dust boot/seal you have in your pic notice the slick area right after the seal is where the d-shaft rides on the needle bearings inside the spindle.
that ********* thing on the shaft is my special driving tool without the handle. I though I had a finished pic with the new seal but I don't.
If you do the u-joint make sure u get the joint with this type of grease cert for clearance.
You must be registered for see images attach
here's a pic of my hub apart. see the giant socket you need for removal in the pic.
You must be registered for see images attach
here's what one ujoint cap looked like when I took her down
You must be registered for see images attach
the bare knuckle
You must be registered for see images attach
this is that messed up dust boot/seal you have in your pic notice the slick area right after the seal is where the d-shaft rides on the needle bearings inside the spindle.
You must be registered for see images attach
that ********* thing on the shaft is my special driving tool without the handle. I though I had a finished pic with the new seal but I don't.
You must be registered for see images attach
If you do the u-joint make sure u get the joint with this type of grease cert for clearance.
Last edited: