Still no power to cab at all. Here is where I am currently tracking. I have all wires off starter solenoid except large red battery cable coming from batt. I will start attaching the 4-5 other wires that go on the hot side of the starter solenoid and as I attach each wire I am checking for a voltage drop at the solenoid. The voltage drops to 10v when I attach the black/orange wire which runs into fuse panel. Then I attach another of the yellow wires which I believe runs to passenger side door panel and voltage drops to 1. These two wires also carry around 1 volt unattached to the solenoid.
Why would they hold voltage unattached to soleniod? Because there is a bad ground somewhere back feeding the circuit?
Why do these two wires cause voltage to drop at the soleniod? A bad ground somewhere? Could a bad connection for power doors or cruise control cause this bad of electrical loss?
Why would they hold voltage unattached to soleniod? Because there is a bad ground somewhere back feeding the circuit?
Why do these two wires cause voltage to drop at the soleniod? A bad ground somewhere? Could a bad connection for power doors or cruise control cause this bad of electrical loss?