injection pump

  1. C

    DB2 Pump doesn't respond to full throttle

    First post here, haven't been able to find any threads for this specific issue and none of my buddies can seem to figure it out. Truck ran great up until a couple weeks ago when I pulled the pump out to put new shaft seals in. Doesn't seem like it has full throttle anymore. Took some time to get...
  2. Stu Bailey

    Anything look weird?

    So a few weeks ago I noticed fuel leaking out of my IP and filling the valley pan. I had been getting worse MPG for a while too so I decided it’s time to pull it and install a new one. Truck is my new-to-me 92 7.3 idi with Banks Sidewinder turbo. Has 161K miles and I believe it sat for a good...
  3. S

    1993 F250 7.3 IDI injection pump

    Have a 1993 7.3 idi (non turbo). I bought the pick up recently, ran pretty well when I first got it, started having some problems with it, some I have worked out but I think I’m still having a serious fuel delivery problem. These two forums pretty accurately describe what’s going on with it...
  4. O

    Reman IP fuel setting for existing turbo?

    Good morning, group. ’93 F-350 has been running an early Banks Sidewinder aftermarket turbo for (apparently) many years before I bought it. IP is leaking now. I’ve bought a reman DB2 5013 to replace same, which was running fine with the turbo, although I understand it is not the recommended...
  5. D

    Injection pump identification

    Anybody know what pump this is.
  6. Minty Ferd

    Engine acts like it hits boost, without a turbo

    I have a 89 F350 7.3 idi with an unknown amount of miles, my guess is it rolled over twice so 214k miles. IP is definitely a replacement because it's not painted. Previous owners were crackheads so no info from them. So I accelerate in third gear (ZF5), steady pressure on the pedal, and it...
  7. Bakersk896

    Cat P-Pump Swap???

    Anyone put a P-pump from a cat 3208 on their IDI? It’s and 11.6L engine rated for around 210 depending on the factory setup. The cc per injection has to be much larger than a DB2. Downside is that even if someone has done it, it would require a custom intake and very little room for a turbo if...
  8. D

    OM606 swap questions

    So it looks like the NA 606 has a mechanical injection pump. So if I had a car that came with a na 606 would a turbo 606 be a direct swap. I would convert the electronic 606 to a mechanical pump. Or would it be easier to get a car that already has a turbo 606 and convert it to mechanical. The...
  9. D

    John Deere 6068 injection pump?

    Anybody know anything on the inline injection pumps used on this engine. I believe the pump model is John Deere 430 S2 pump/SE501758. Can the pump be turned up how reliable are these pumps.
  10. F

    Issues with starting

    Hello everybody I’m having some trouble. Set in the other night and decided to do the injection pump, (she runs like a top now.) Now I’m having a problem of when the truck is warm it will not fire back up easily, but it will finally cough some black smoke and roar to life. Does anyone know of...
  11. stick_witch

    7.3 idi compression test numbers and discussion

    Hey guys! I just did a compression test on my truck while I have it torn apart. New to these motors and diesels in general so if anyone could shine some light on this topic that would be great. Results: 380psi @ 21 compression strokes 380 @ 21 340 @ 21 340 @ 21 380 @ 21 295 @ 21 440 @ 21 420...
  12. stick_witch

    7.3 IDI injection pump removal and compression testing after the fact.

    Hey guys! So I've got my truck in the shop to fix some oil leaks and to replace my leaking injection pump and I got overly excited and took off the IP and disconnected the hard lines running to and from the fuel filter head without doing my compression tests on the cylinders of this new to me...
  13. H

    Elevation

    So I just drove my 1985 6.9idi truck from Washington to Colorado. (Elevation from 100ft to 7000ft). Before I left I changed the injection pump which was on its way out. I have the timing slightly advanced which is how The old one was. I noticed that with the new pump I am getting a lot more fuel...
  14. ocnorb

    1994 IDIT timing w/J33300 issue

    Truck is '94 F-350. I'm using the Kent Moore J33300 that I've had for 10+ years, but I haven't used it for a long time. Timing light is an ESI that does not have any advance dials. Just straight up zero. Using a fuel line ferret on #1 cylinder. I marked the dampener and the sight with white...
  15. E

    Won't shut off when hot

    I have a 1984 6.9 and when it is hot, it won't shut off. It has a turbo cool-down thing that is supposed to keep the engine running until the EGT drops below a certain level so I first thought it was that but its electrical and the beast kept running even after I disconnected all the wires to...
  16. Oldtowntrucks

    injection pump replacement

    My old pump is leaking pretty bad, time to replace it off my '93 f250 7.3 idi e40d. Looking to purchase a reman one hopefully to save on some cost, probably from Rockauto unless their is another suggestion. Looking at this Delphi Stanadyne reman IP...
  17. T

    '93 7.3 NA IDI loss of power @ 2000rpm runs rough

    Hi guys, Ive got a 93 7.3 non turbo idi. I have noticed a fuel leak coming out of the injection pump where it meets the timing gear cover and has suffered from cold start issues. The truck is just now running extremely rough and excessive white smoke especially over 2000 rpm and barely enough...
  18. 86 Ford F-250 4X4

    6.9 Diesel starts and will only runs for a seconds, billows white smoke.

    I have a ’86 Ford F-250 6.9 diesel that has less than 18,000 miles that I bought new. I had not started it in several years and when I turned the key the fuel gage showed empty on both tanks. I tried starting it and it would not run. I thought either the gage was broken and the fuel was bad or...

Latest posts

Forum statistics

Threads
91,263
Posts
1,129,497
Members
24,093
Latest member
93 Farm Truck

Members online

Total: 626 (members: 8, guests: 618)

Share this page

Top