For a couple of picture's check out kijiji.ca item # 93212305
1993 Ford F-350 regular cab long box with an international 7.3L IDI turbo diesel engine, 5 speed manual ,4X4, dana 60 axle's 6" skyjacker suspension lift
182xxxkm, Ok so now a list of what i've done to this truck:
-35" Dick...
So i can put the hubs in the free position but they don't seem to disengage. When i spin, try to spin the front drive shaft it moves a bit then locks up, WTF??? Are the hubs just shot or is there a bigger problem??? The drive shaft should spine freely when there in the free position correct...
So today i finally turned up the fuel screw maxed it out. now i see about 9.5 pounds of boost before 8.5 pounds of boost. When i rebuilt the turbo i bench tested it for 11 pounds before the wastegate comes on. barely any black smoke just a small puff under load going up a hill. Do i need...
Yeah so i'm looking at some new injectors for the hoss called dps today they seem super reasonable at $288 for new injectors wondering whop has these installed and what kind of gains you got?? Also who else makes injectors for the idi's??
So here is my totally rebuilt turbo painted in ford blue along with the air intake pipe 3" flared at the end to accept on afe filter. New bearings and all that on the turbo, the waste gate was set in the shop at 11 psi but i still only get just above 9 on the road will try turning it up some...
Does some body have a write up on adjusting the waste gate on a stock turbo??? Now that i got some gauges in the truck would like to turn it up to say 12 ish pounds? That's about max eh for a stock engine?
Got some gauges today and need to get them in. Pyro seems simple enough, just going to go after the turbo. But where do you put the hose for the boost gauge???
How do you cahange that rod that comes out of the clutch master cylinder??? Replaced the lever that clips in to the rod yesterday but want to change the rod now, Cant see you just pulling it out??
So i unhooked the wastgate vacum line?? thing from the turbo and now she snorts so much better!!! Is there a way to dial it back some with out unhooking it all togher??? How bad is this for my turbo's life do ya figure? Thanks
New to me 93 f-350 4X4 5 speed , 94 turbo engine installed in the truck buy the previous owner. 6 inch super lift riding on 35"S now. going to make an intake today and remove the whole old box. Any sugestions for more power would be nice.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.