Search results

  1. B

    Injection pump cores.

    Have 10-15 maybe more 6.9 7.3 injection pump cores. I am know that some of them were running fine, but unfortunately stuff was not labeled, and has been moved around and I just dont remember. Also have incomplete pumps and pump parts. What do I do with this stuff? Will be keeping a couple...
  2. B

    T19 bellhousing

    I remember saying awhile back that the 460 t19 bell wouldnt work for redrilling the 6.9 7.3 pattern, because the one that I had wouldnt work for sure...... Well, aquired a few different bells (all alum hydraulic bells, and the 460 and idi bells are the same casting. The 460 bell for sure could...
  3. B

    Grid heater controls?

    Picked up a first gen that is donating its motor to a ford. Truck is a 90, and all wiring is intact, and does run the grid heater when you turn the key on cold. My questions are, below what temps does the factory controller start to run the grid heater, and is the controller system worth...
  4. B

    Serp belt dual alts??

    Anybody ever see a dual alternator setup for the serp belt system? Have an idit motor that will be going in my truck, and have been thinking about dual alts. At times It does a fair amount of winching, and though the 3g does awesome, it would be nice to split that load, or even just have the...
  5. B

    Factory turbo/ats 093 low rpm boost.

    Been so long since I used one, I dont remember.... At what rpm do yours start showing boost, and how much?
  6. B

    Idi dyno tests

    With these higher mm3 pumps, better injectors, and turbo upgrades that are now being sold, is any of this stuff being dynoed? Have never seen anything posted ( maybe its on some other social platform?).
  7. B

    G codes

    Anybody seen any of the g codes available anywhere? Anybody building injectors using that nozzle? have a set that is getting pretty worn, and I prefer them over the other letter code injectors.
  8. B

    Starting without glow plugs.

    I have replied to many threads over the years, sceptical of claims of starting in warm weather without glow plugs. I have owned so many of these and even the ones that started good in cold weather still needed some plugs when it was hot out with a cold engine. Well, I now have one that starts...
  9. B

    Oil cooler o rings.

    Have been doing many oil coolers on the idi pickups as well as 7.3 powertroke trucks lately. The last several I used permatex tune up dielectric grease on the o rings for lube. I have used many different things over the years, but for what ever reason this stuff is by far the best I have used...
  10. B

    pump and injector cores?

    Anybody buying these? Trying to clear up some space and I have a lot more of this stuff than I realized.
  11. B

    6.9 7.3 oil consumption?

    Have had many of these over the years that burned huge amounts of oil, but never really tried to fix one. Anybody tore down a major oil consumer, and what did you find?
  12. B

    valve stem seals and oil consumption

    Anybody had lowered oil consumption after replacing stem seals? I did a couple 6.9s years ago to try to lower consumption with no change. My 7.3 has been using some oil for along time now and the amount has risen sharply in the last couple years. This has been with very little use of the...
  13. B

    7.3 controller glow time.

    Any body played with different wire/cable size to the gpc to alter glow time? On my truck I get a full 20 seconds (this morning at 20 deg) first cold start. Havent checked voltages or voltage drop to controller, but in theory the factory wiring must be tired, causing volt drop at gpc and long...
  14. B

    in need of 085 cartridge

    Any body here provide one? My local source that I have gotten the last few from claims they no longer can get them.
  15. B

    what 4kw starter?

    what one have you guys had the best luck with?
  16. B

    echlin (napa) new injectors

    I have stated in the past that these were good injectors and readily available....well they still are readily available but good ,not soo much. I have used around 10 sets of these, tested before install, and pressures were good and consistent and the trucks they were installed in still run...
  17. B

    085/088 air filter

    Does anybody have a good part number for this air filter? it is the rectangle shaped box. thank you.
  18. B

    what is this 7.3 idi turbo worth?

    Have a running 7.3 with an 088 kit, that needs: turbo cartridge valve cover gaskets complete fuel system engine is healthy, and under 150k I just need an idea what to sell this locally for. I have a buyer, just dont want to charge him too much for it. thanks guys.
  19. B

    early 6.9 piston cooling nozzles?

    I have a really low mile rebuild 6.9, that two of the nozzles (re used in the rebuild) fell out of. I am looking, but cant find a new set. Anybody know where to look?
  20. B

    delphi injectors, two part numbers??

    Lately the local parts stores have been selling the delphi injectors, and list a different part number for the 93-94 turbo motor. Any of you guys selling these injectors have any thoughts?
  21. B

    6.9 weight??

    Has anybody ever weighed one? Wanting to do a swap, but need to know actual weight before I decide
  22. B

    shifting us gear overdrive

    I have this overdrive behind a t-19. I am having no trouble shifting the overdrive while accelerating, but trying to down shift the overdrive while maintaining speed or slowing down i get a long grind. I am sure I am just doing it wrong. anybody drive this combo often? If you were cruising...
  23. B

    6.9 to zf.. what clutch?

    I recently scored a zf/us gear combo, and it is time for my e4od to leave. Truck will be getting a 6.9 at the same time (with stock solid flywheel) and I cant remember what clutch should be used. truck as it sits now is 7.3 and e4od.
  24. B

    cartridge for 085 kit?

    Any body have a good supplier? I am needing one for my truck, and the wheels have been rubbing, guessing it will be easier to just get a cartridge than rebuild. borg warner part# 166198 to4b98
  25. B

    94 460 mpg

    In a recent trade, I ended up with a 94 f350 4x4 regular cab single wheel. It has the 460 with a c6 and 4.11 gears. This has to be the latest I have seen with the c6. anybody have/have had a similar truck? I am wondering what I can expect for mpg. truck is 100% stock and 214k.

Latest posts

Forum statistics

Threads
92,992
Posts
1,155,909
Members
26,569
Latest member
Nolan_P

Members online

Total: 1,418 (members: 8, guests: 1,410)

Share this page

Top