Recent content by jlpdemag

  1. J

    7.3 NA Wiring Help Needed

    Thanks! I think that is exactly what I need!
  2. J

    7.3 NA Wiring Help Needed

    Ok guys I'm putting a 7.3 IDI NA in a '63 Scout 80. What I don't know is what is the bare minimum wiring needed? I can handle the ALT wiring but need to know what is involved for the motor itself. I do have the original glow plug wiring harness on the engine right now. Bare minimum is what I'm...
  3. J

    IH Scout 80 Build w/ 7.3L IDI Drivetrain

    It's not that long actually. NP203 GRB (5.75"), 203-205 adapter (3") and NP 205 (12.5" from front surface to the center of the rear output yoke)With the 100" wheelbase things should be ok. I'm not far enough along to kow what my angles are yet but axle cut and turns are in the plans.
  4. J

    IH Scout 80 Build w/ 7.3L IDI Drivetrain

    Exekiel69, I don't know the history on the motor, nor does the PO I bought it from. He bought it as a parts truck for the body. The motor was still in the truck but the trans was out of it. There was a T-19 and a solid flywheel in the bed of the truck along with the tcase. I would like a ZF too...
  5. J

    IH Scout 80 Build w/ 7.3L IDI Drivetrain

    Hey guys. I'm new to this forum but I'm sure I will be here more and more with my current build in full swing. Here's the basics: 1963 International Scout 80 Body 1975 International Scout II Frame and Axles (Dana 44 front and rear) 1988 International/Navistar 7.3L IDI from Ford F-250 T-19...
  6. J

    Flywheel Question?

    Here's the link to the build thread over on the IH Binder Bulletin Forum: clicky The thread is geared towards the IH/Scout folks. I'll work on a diesel repower thread for the forum here covering the mods and install of the drivetrain in the IH platform.
  7. J

    Flywheel Question?

    I would love to have a 5 or 6 speed but my install is in a '63 Scout 80. Current plan is to run the 7.3 IDI with the T-19 into a NP203 gear case mounted to a Chevy NP 205 for the passenger drop. This should be PLENTY of power for a little 80. I don't know if it's bad form to post links to...
  8. J

    Flywheel Question?

    Thanks. That sounds right since the trans in the back is a T-19. Verified by the casting numbers in the side of the trans. So, if that is the case can I just bolt up the solid T-19 flywheel and the T-19 and go to town?
  9. J

    Flywheel Question?

    Any ideas?
  10. J

    Flywheel Question?

    Hey guys some of the folks at the IH site I am active on suggested I ask for your help on this. I just purchased a used 1988 7.3 IDI for a project Scout of mine. The motor was in the truck when pulled but the trans and tcase were in the bed of the truck when the PO bought it. I bought it all...
See more

Latest posts

Forum statistics

Threads
91,345
Posts
1,130,759
Members
24,143
Latest member
Cv axle

Members online

Total: 308 (members: 10, guests: 298)

Share this page

Top