When I blow into the vent tube fuel comes back out the filler neck.
Is that normal.
I can't get fuel into the front tank so I have cleaned the vent, removed the metal neck to check the inner hose to make sure it wasent dislodged...
What causing the key to bump back to the off position when i shift the lever on the column. Aotomatic
If i keep my hand on the key with a little preasure no problem.
I popped out the tumbler and cleaned it up to try and help. Is there suspose to be some sort of spring or detent ball in...
Are the springs sided ... Got a pair from the wrecker casue, the one on the truck has broken leafs and only the main leaf is there... But is the passenger leaf suspose to go on that side or can they be swaped sided to side. Set from the wrecker are not marked
Aw think i answered my own guestion. The box has the part # 354 g but the joint is stamped 352, anyway, pulled out the drive shaft to check, but the caps a smaller.
Does nyone know if. F 350 u joint is the same as a f 250.
I found a u joint in the parts shed cause one rear u joint needs replacing. I think its a spare i had for the gmc, part number 534G ,
Moog web site says it will fit f 350 thought id ask here before .... Thanks
What would cause the milage to increase? Ive put about 5 gallons mix wmo into the truck and seems as though the fuel consumption has go way down.
Usually would hit half tank with straight diesel in 200 kms. Now its 150 kms and only 1/8 tank.
Is this due to worn injectors and thicker fuel...
yes it seems to start hot. probably could have saved some monies if I went with a new starting motor first. the starter looked new that's why I didn't replace it. I guess the PO burnt it up when trying to start it with the bad lift pump.
anyway, certainty didn't hurt installing the IP. ill...
also, did the rear dif come with a Detroit or a locking dif from the factory, this truck is definitely locked back there. I wonder if its been welded closed?
should the front drive shaft engage while in motion without the hubs locked?
I pulled her into 4x4 just to try it and it wouldn't engage until stopped. the hubs where unlocked
so far, ive been going to work put in a day and come home. trucks been starting, but just cold starts
. adjusted the fipl tonight and installed a reman starting motor. I love the top bolt on the starting motor. tasted the tire, tasted the front spring, eat some gravel and burnt my wrist. but...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.