Recent content by Andrew M. Frankli

  1. Andrew M. Frankli

    93 f-350 idi SRW Rear seal woes. This thing is eating my lunch!

    After 3 tries getting the correct part, I destroyed it trying to install. It appears to be a 3 piece design with a collar, wiper, and stamped ring. The wiper part is designed to fit tight on the spindle shoulder and the rotating seal surfaces are "within" the seal assy. Outer seal piece...
  2. Andrew M. Frankli

    99 psd f-350 vacuum hose

    Hi Friends. Help! I'm replacing glowplugs and gaskets/harnesses to see if I can make this thing start better and run better. I noticed two vacuum hoses coming from a module on top of the engine. Green on bottom Red on top. Where does red one go?? Can't find anything! Also, this thing blows...
  3. Andrew M. Frankli

    WHOAAA DADDY! New Injectors = new truck

    Just put a set of new BB injectors in. I've had truck for 5 years and have no previous service history. The old ones were Italian Stanadynes and looked pretty charry-gunked up. Truck always ran okay, but lately cranked longer before starting and seemed a little smokier and poochish. Now...
  4. Andrew M. Frankli

    Help! Starter Solenoid Energizing Problem

    Neut saf switch Sorry I didnt mention that I replaced the neut saf swi. Where does starter solenoid energizing wire go? I am trying to backprobe it without taking the truck apart ;)
  5. Andrew M. Frankli

    Help! Starter Solenoid Energizing Problem

    Hi. I am going nuts on this one. 1996 E-350 Club Wagon won't crank. I can bypass the solenoid up on the core support by the battery with a screwdriver and it fires right up (of course, with ignition switch in "run" position - this is a 5.8 gasser). Red with sky blue tracer wire that...
  6. Andrew M. Frankli

    Water Pump area coolant leak 93 IDI

    Hi -Is there a weakness on the water pump area sealing on these old IDI's? My truck leaks water from around the water pump area and I can't see exactly where it is coming from. It is a big job, but I guess I have to just start pulling parts. Any experience like this?? --ANdy
  7. Andrew M. Frankli

    SOMEONE Please sell me some injectors!

    SORRY, MY BAD. WENT INTO JUNK EMAIL FOLDER Thanks, Russ. I found your email in my junk folder. Hotmail does such a good job filtering true junk, I rarely check it. I will mail a PMO on Fiday. Thanks again! --Andy PS Agnem: I didn't contact you directly - you would have been my next...
  8. Andrew M. Frankli

    SOMEONE Please sell me some injectors!

    Hi. Thanks for responses to my post regarding rebuilt injectors for my 1993 Non-Turbo IDI. It seems the best way to go is with new Delphi BB injectors from TYP4 (Russ) or AGNEM. I emailed, phoned, and PM'ed Russ over the past 4 days and have received no response. I don't want to stalk...
  9. Andrew M. Frankli

    Who can rebuild my injectors?

    I want to have my injectors rebuilt - They are original to my truck and I would just as soon have them rebuilt rather than getting someone's else rebuilt injectors. The truck can be down for a while... Anyone know of a good source? If I can't do this, what are the best injectors to get, and...
  10. Andrew M. Frankli

    Caterpillar 880 cca batterys junk in 1 year?!

    Well, I sprang for genuine Caterpillar batteries p/n 230636x last July (2009) after reading on this forum that there IS a difference... $115.00 each - no big deal, well... Sure enough, once or twice during the summer when the truck sat for a week or so it sounded like it was cranking a little...
  11. Andrew M. Frankli

    E4OD wierdness. Anyone experienced this?

    No mods other than the Banks shift enhancer module and supplemental trans oil cooler.
  12. Andrew M. Frankli

    E4OD wierdness. Anyone experienced this?

    It is intermittent within the same drive cycle. I assume if the stalk light is not flashing, there are no codes. I will try to pull them anyway. Does it wet or dry, warm or cold. Thanks, Ben for the suggestion. This is exactly what it is doing. I haven't checked for TC lockup yet - will...
  13. Andrew M. Frankli

    Starting My A/C conversion to R-134A

    My experience is the same as oldbull8 except for one thing: 20 degrees is what I would consider the MINIMUM differential between air temp @condensor and evaporator. I routinely get 30-35 degrees differential on healthy older 134a systems.
  14. Andrew M. Frankli

    E4OD wierdness. Anyone experienced this?

    Just out of nowhere my trans seems to have difficulty accelerating in "D" selector position. It feels like it is trying to start out in 2nd (or maybe even 3rd) gear. Doesn't really pull until rev's are around 2000, then labors to accelerate. If I manually put it into "1", it accelerates...
  15. Andrew M. Frankli

    batteries

    Cat Batts I went through two Interstates and two other name brand batteries in my truck. Only got a couple years out of each set. So last year I popped for Genuine Caterpillar '31's (recommended by several on this site.) So far I am happy - though my truck sits for several days at a time...
Top