-
-
BBlack dawg replied to the thread 85 6.9 IDI Will not run.Very interested to know what went wrong in that pump.
-
BBlack dawg replied to the thread 85 6.9 IDI Will not run.Do you have return flow out of the pump?
-
BBlack dawg replied to the thread Throttle Cable Receiver Connection keeps "Popping Off" of the Injection Pump Arm.What happens when you manipulate the throttle holding that cable end, or removing it from the vacuum servo and pulling on that end? My...
-
BBlack dawg replied to the thread Truck running weird.Good luck trying to get any work done with one shifting like that. Even with a splitter, shift points in mine working, are 2500ish.
-
BBlack dawg replied to the thread Throttle Cable Receiver Connection keeps "Popping Off" of the Injection Pump Arm.Just looked at a couple of mine. Springs are all connected to the pump arm above the ball.
-
BBlack dawg replied to the thread Harsh upshifts in a "rebuilt" E4OD. Found only one spring in each accumulator valve..did the trans work before you added 3 gallons of fluid to it? What voltage did you adjust the tps to, and does the voltage change with...
-
BBlack dawg replied to the thread 7.3 idi injection pump leaking from advance piston..Did you feel how well that seal fit on the pin? I assume it is leaking on the id of the seal, or is ot leaking around the od?
-
BBlack dawg replied to the thread South Bend clutch chatter.Have used a few southbends, as well as other performance type clutches....no chatter.
-
BBlack dawg replied to the thread 2000 mile trip in 1990 F250 with 2,400 lbs in bed?.2500 really isnt that much in one of these trucks, especially if it has the overload on top of the standard spring pack. On my truck...
-
BBlack dawg replied to the thread Grease for driveshaft slip yoke splines?.If the splines have the blue stuff on them most any grease will do. Stickier seems to be better. Where that ford grease shines is un...
-
BBlack dawg replied to the thread Tach cutting in and out.Really need to verify that power from the tcm relay to the tcm is solid. After that, grounds to the tcm. what I have seen several...
-
BBlack dawg replied to the thread Tach cutting in and out.From what I remember, the tach goes to the ecm before it goes to the cluster. If the computer is in the stock location, water runs down...
-
BBlack dawg replied to the thread 97 stroke.People buy cars and guns based on emotion. Doesnt have to make any sense...... But, I really dont understand the draw to those...
-
BBlack dawg replied to the thread While the truck sits unused.. can I/should I soak the cylinders?.Or the valvoline restore oil. The diesel stuff is real expensive. But it does work.
-
BBlack dawg replied to the thread While the truck sits unused.. can I/should I soak the cylinders?.The problem is, that anything that will actually dissolve or break down any of the stuff on the pistons/rings/lands, also tends to be...
-
-
Loading…
-
Loading…
