I sure hope so, heck last night I was dreaming about driving my truck again
In honor of project big red I decided to get my exhaust wrapped up. It took some looking but I found a local place that would sell me some mandrel bent 90 deg elbows. All the piping under my truck is 4 inch but I can't sneak that up into the engine bay so I am using 3 inch for a down pipe. My turbo actually has a 3.5 inch outlet so I had to drop that down and right away to clear the heater box.
You must be registered for see images attach
I took the old down pipe and capped it off. I then cut it back out to fit the 3 inch bend I cut at an angle.
You must be registered for see images attach
I realized I am missing my v band clamp so I could not quite finish everything but it is close. I just need to clamp the turbo down pipe tight and should be able to finish it up when it comes in.
You must be registered for see images attach
The rest of the exhaust is a standard diamond eye kit for a power stroke.
Sent from my SPH-L720 using Tapatalk