Lifted Mudder
Registered User
I am currently swapping my 6.9l out with a 7.3 psd and am going to use my t19 until i have enough money for a nice clutch and a zf5. I am wondering if anyone has bolted a 6.9l clutch to a 7.3 psd flywheel and ran a t19?
Powerstroke swap with 6.9 clutch
- Thread starter Lifted Mudder
- Start date
79jasper
Chickenhawk
That won't work. Balance is off.
You need the psd flywheel and pressure plate with the t19 clutch disc.
Sent from my SAMSUNG-SM-G935A using Tapatalk
You need the psd flywheel and pressure plate with the t19 clutch disc.
Sent from my SAMSUNG-SM-G935A using Tapatalk
Lifted Mudder
Registered User
Well that is perfect because I have a pressure plate and flywheel for the 7.3 but the clutch disk springs fell apart. Thanks for the info
riotwarrior
Full Access Member
W T F
Lifted Mudder
Registered User
What? I will confirm if this works when I put it together. Would be a nice piece of information.
icanfixall
Official GMM hand model
Same here Al... The psd flywheel bolt pattern will not match the parrten on any idi crank. But it was a nice idea. Sorry.
Lifted Mudder
Registered User
Not trying to be a pain but I don't believe that you read my posts. I am going to try a 7.3 powerstroke with a 7.3 psd flywheel and clutch and a t19 and the friction plate from the 6.9.
Sparky95
Full Access Member
A powerstroke with a 4 in the floor? Good God at the badassery.
riotwarrior
Full Access Member
Totally read it...totaly understand...still
W T F....
is all....there is a PS section for these PS queztions
W T F....
is all....there is a PS section for these PS queztions
FarmerFrank
Full Access Member
He's not really asking a psd technical question... Kinda a mix of Idi and stroke but the swap section might give him some good indication on what will work
Sent from my iPhone using Tapatalk
MTKirk
Full Access Member
I'm intrigued, please post up with how this turns out.
IDIoit
MachinistFabricator
i know that the t-19 to ZF5 have different diameters on the clutch guts.
that said, i dont think the t19 disc will work with a psd pressure plate.
ive always just saved up to do the job as correct as i can.
that said, i dont think the t19 disc will work with a psd pressure plate.
ive always just saved up to do the job as correct as i can.
Maybe redrill PSD flywheel to use t19 clutch. Does the t19 bell housing line up on a PSD?
IDIoit
MachinistFabricator
the t-19 and the PSD zf5 are swappable, so i think he's good on that aspect
Black dawg
Registered User
a clutch shop should be able to look at some pieces and figure out something that will work for you....but as easy as it would be to just put a zf in, it would fix two problems at once.
