Hood water seal thing

riotwarrior

Full Access Member
Joined
Sep 19, 2006
Posts
14,782
Reaction score
492
Location
Cawston BC. Canada
Soke folks have said garage door seal on bottom of door works IIRC and it is bulk length in hardware stores;Sweet thus failure on road ....easy peasy fix....bobs yer uncle n done
 

BrianX128

Full Access Member
Joined
Dec 3, 2015
Posts
1,845
Reaction score
604
Location
Pittsburgh
You can bend a rod if you try to start it thinking " Starter worked fine before that shower & now won't turn over" .

Been there/done that. Starter is unbelievably stout!!

Rick


The starters are a bit amazing. I had one get stuck while trying to start in winter with bad glow plugs and just a lot of stuff that needed worked on. I couldn't get the battery cables off to get it to quit turning over and it was stuck at the starter so in a mild panic not wanting to burn the rest of the truck up I let the clutch out slowly in first, truck started climbing the driveway. To my amazement it did in second and even third! I finally let it out slow in overdrive and it couldn't do it clutch wouldn't slip either so it overheated the starter and made a little pop and I will never do that again, but was actually kinda cool to see it would do all that.
 

The Warden

MiB Impersonator
Joined
Jan 12, 2005
Posts
7,356
Reaction score
39
Location
Fog Bless Pacifica (CA)
The starters are a bit amazing. I had one get stuck while trying to start in winter with bad glow plugs and just a lot of stuff that needed worked on. I couldn't get the battery cables off to get it to quit turning over and it was stuck at the starter so in a mild panic not wanting to burn the rest of the truck up I let the clutch out slowly in first, truck started climbing the driveway. To my amazement it did in second and even third! I finally let it out slow in overdrive and it couldn't do it clutch wouldn't slip either so it overheated the starter and made a little pop and I will never do that again, but was actually kinda cool to see it would do all that.
My clutch slave cylinder committed suicide while I was towing an 8,000lb trailer and coming up to a toll booth :shocked: after paying the toll, I shut the engine down, put it in gear, and cranked the starter...even with the trailer strapped to my truck, the starter had enough power to move the entire rig AND start the engine :shocked: with floating gears, I was able to get to the destination...it really is amazing what these starters are capable of!
 

Knuckledragger

blowing chunks and grabbing porcelain
Joined
Nov 7, 2008
Posts
2,354
Reaction score
240
Location
Payson, AZ
I like the garage door seal. I bought a new seal from LMC and was dismayed to find that none of the screw holes matched the truck locations. It would have been better if there were no holes punched from the get go.
 

Forum statistics

Threads
92,996
Posts
1,155,953
Members
26,579
Latest member
truckonfire

Members online

No members online now.
Top