Mr_Roboto
Full Access Member
This is a leftover case, I took it to be rebuilt and basically all the parts inside were fried so I got a used trans to replace it. It's been sitting in my garage for 2 years now and I'll never use it, but I hate to just take it for scrap.
All that's there is the case, extention housing and output shaft, and some bits and pieces that weren't taken out. I probably have a pan to go with it somewhere too.
This is out of a 1994 E350 van and was bolted to a 7.3L IDI
This would be good for a mockup, it might be able to be used to swap gasser guts into, but I cannot guarantee everything is good in the case, it did get pretty hot when the trans failed.
Local pickup only at my house in N Ridgeville, Ohio which is about 20 miles west of Cleveland and accessible by I80, I90 and I480.
All that's there is the case, extention housing and output shaft, and some bits and pieces that weren't taken out. I probably have a pan to go with it somewhere too.
This is out of a 1994 E350 van and was bolted to a 7.3L IDI
This would be good for a mockup, it might be able to be used to swap gasser guts into, but I cannot guarantee everything is good in the case, it did get pretty hot when the trans failed.
Local pickup only at my house in N Ridgeville, Ohio which is about 20 miles west of Cleveland and accessible by I80, I90 and I480.