I pulled solenoid pack and double checked with vom, all was within specs from diagram in earlier post. reinstalled and rechecked codes. still had 22 and 11, 92 was no longer there? not sure what had changed? when I changed the plug, all connections were soldered and heat shrink sealed. had the...
ok, everything works now! what a pain in the ass!!! cant believe someone would build something so complex, relying on shit that is completely un related. now that it is working, just bought a complete running 5 speed f250 for the swap. might even install a manual fuel cut off. all I can say is...
ok replaced solenoid plug, adjusted tps many many times. best I could get on tps was 1.18-3.98. all codes are gone except code 22& 92. did drive down the street and seems to be shifting through all gears. tried clearing code, still there. after it reads the two codes I get code 11, system...
range sensor is original/well the one off tranny that was in truck. pulled codes, 56, 22, 23, 82, 92 wot. cleared codes then checked again no wot, 56, 22, 23, 92. wow the 92 scares me, not sure which way to go now?
installed new solenoid pack today, did change things but....... still not working right. put in drive and takes off in 2nd and will not up shift unless I put gear selector in 2nd then back to drive, then goes into over drive. sorta like before but not locking up converter now. come to a stop...
ok here,s the scoop. old trans has the proper plug set up. new trans has new style. the female plug on the harness is missing the snap clip that if on there would keep it from sliding in. so with that said, you can slide a broken plug into new solenoid pack. going to get new pack and hopefully a...
I am going to drop pan, forgot magnet when I was flushing it out ooppss. going to pull solenoid pack while I'm in there. will compare to old one. not sure old trans was right either. just talked to person who sold me the trans, said it did come out of newer turbo 7.3. well newer than 92. he...
I did not do any alterations to anything, the plug look the same when both were on the ground. only change was converter. if the solenoid pack is different, I did not see it, how it is sorta working I do not know? can I change out solenoid pack to hopefully correct?
update, take off in drive and no shift from first. pull shifter to 2nd and it goes into second. put back in drive/od and it shifts and locks converter immediately. od button on shifter has no effect and is not blinking???
Sorry for the long story!!! Bought a used 350 dually, reverse worked fine. almost no forward. down hill with high wind and it might move. Picked up a used trans at a scrap yard, flushed it out and new filter before the swap. during swap i noticed new converter has 6 studs, old one has 4. flushed...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.