I just replaced the glow plugs on my 1992 7.3 IDI with Motorcraft brand.
The existing glow plugs were Bosch , only 3 out of 8 were good. None of them were swelled, came out super easy. Is Bosch a good brand for these engines? Starts 100 x better now with a good set installed.
I used the bottom...
I had some time today when it wasn't raining or snowing and pulled the first glowplug on the right side looking at the engine. It was a Bosch brand. Tested bad with a test light Not swollen. I noticed that after replacing just this one plug the wait to start light stayed on longer than it ever...
What is the purpose of the return line from the filter housing to the number 1 injector? A lot of people are plugging the filter housing and using a deadend cap at number 1.
I'm not understanding why it's there. It's another source of air intrusion with it in place.
I also wanted to ask about the bolts on the tensioner and idler. I think the tensioner assembly bolt is RH thread and the idler pulley is LH thread. Is that correct? The belt direction is LH on the tensioner pulley so it would be LH thread as well?
The belt tensioner on my 92 7.3 has the open spring design. It looks like a replacement. It bounces as the belt turns. Is this normal ? Tension on the belt is fine.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.