Recent content by 94crewcabIDI
-
Heavy duty bumpers
Shouldnt bumpers on 92-97 trucks work just fine? They are the same frame if I've read everything I've read correctly. And I see all sorts of bumpers available for that body style- 94crewcabIDI
- Post #16
- Forum: 6.9L IH & 7.3L IDI Diesels
-
E4od shifting hard
I took the map sensor off of my Fathers 7.3 and put it on my truck. It still threw that code. My Fathers truck does not throw that code though. so my plug or my wiring is messed up on my Truck- 94crewcabIDI
- Post #12
- Forum: 7.3L Powerstroke Diesels
-
E4od shifting hard
My edge evolution tuner says map sensor isn't getting correct voltage and pcm memory or something. But when i went to oreilly before it got 0 codes from engine or tranny- 94crewcabIDI
- Post #10
- Forum: 7.3L Powerstroke Diesels
-
E4od shifting hard
It fixed my torque converter problem. It still shifts bad- 94crewcabIDI
- Post #8
- Forum: 7.3L Powerstroke Diesels
-
E4od shifting hard
Well i got the third brake light fixed- 94crewcabIDI
- Post #7
- Forum: 7.3L Powerstroke Diesels
-
E4od shifting hard
I will check the light today. my tach only works half the time- 94crewcabIDI
- Post #5
- Forum: 7.3L Powerstroke Diesels
-
E4od shifting hard
Hey y'all. I just bought a 1997 f350 2wd cclb dually. The transmission is shifting hard in all gears. And it's as if the torque converter isn't locking correctly when I try to maintain a higher speed (50 or over) it's got brand new atf the amount of quarts the manual says to have. Trucks runs...- 94crewcabIDI
- Thread
- Replies: 11
- Forum: 7.3L Powerstroke Diesels
-
Bumpers
So I'm looking at a 1988 f350 rclb dually 4x4 5spd 7.3idi tomorrow. The front bumper is tweaked and I don't like that. Are the bumper mounts the same on the 88 as a 92-97? If so how well would a legend series ranch hand look on an ol brick nose? On another note this truck has problems starting...- 94crewcabIDI
- Thread
- Replies: 2
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Brakes not working
Hey guys. My 1997 f350 pstroke is having brake problems. All the brake material is about half way warn so that's fine. The back brakes are adjusted correctly. It's not using brake fluid at all. I just replaced the vacuum pump not too long. The brake pedal just goes straight to the floor. This...- 94crewcabIDI
- Thread
- Replies: 1
- Forum: 7.3L Powerstroke Diesels
-
97 f350 front springs
Even so wouldnt there still be arc differences? I see lower 4x4 trucks like mine with the straight axle so idk what to do- 94crewcabIDI
- Post #5
- Forum: 7.3L Powerstroke Diesels
-
97 f350 front springs
Its straightened out. It wont measure right- 94crewcabIDI
- Post #3
- Forum: 7.3L Powerstroke Diesels
-
97 f350 front springs
Hey all. I have a 1997 ford f350 crew cab long bed 4x4 with the 7.3 psd. The front spings are bowing upwards and i need new ones. But it has a 4 inch block in the back and the front have no blocks. They would be the same height and i see alot of them the same height as mine so maybe its factory...- 94crewcabIDI
- Thread
- Replies: 8
- Forum: 7.3L Powerstroke Diesels
-
-
7.3 idi oil leak
Okay. Since i replaced the passenger side headgasket already should i do it again?- 94crewcabIDI
- Post #59
- Forum: 6.9L IH & 7.3L IDI Diesels
-
7.3 idi oil leak
Okay. Any thoughts on cheapest gasket set?- 94crewcabIDI
- Post #57
- Forum: 6.9L IH & 7.3L IDI Diesels
