KansasIDI
Latest activity Postings About
-
-
And let the fun begin..... -
KansasIDI replied to the thread So what did you do with your truck today?.Thank you. You too.
-
KansasIDI reacted to XOLATEM's post in the thread So what did you do with your truck today? with
Like.
That is one nice truck. Not that I would ever be riding in a 'smart' car...but I would hate to be in one and have that truck right on... -
KansasIDI replied to the thread So what did you do with your truck today?.@XOLATEM Sorry, I’m not so good at taking pictures
-
-
KansasIDI replied to the thread HF Trailer Wheel Bearing temps.I did torque by spec on my Dana 60 front axle, doesn’t get hot, new wheel bearings, seals, grease. But I still made sure that it ‘felt’...
-
I just like my idi because its not a gasser. Always been a fan of diesel, that's why all our cars are diesel, except the samurai. And...
-
KansasIDI replied to the thread is there a IDIA group around?.Others here may have a very similar problem, such as myself… I’m very sure I know much less than you do though.
-
One Fancy Centurion up for auction! https://bringatrailer.com/listing/1992-ford-f-350-13/
-
KansasIDI replied to the thread Return line question.What you are describing is commonly called fuel drain back or fuel bleed back
-
KansasIDI replied to the thread So what did you do with your truck today?.Thank you. I think the bumper really sharpened it up. I’ll get you more tomorrow morning
-
KansasIDI reacted to XOLATEM's post in the thread So what did you do with your truck today? with Like.
That is one beautiful truck...!!! It is funny that I was thinking about adding something like that front end to mine, as...
-
Put a bypass switch on glow plug so don’t have to cycle every time don’t need to when engine is hot. As well put a 12v 10 psi pump on...
-
$150, shipping included. York AC Compressor mount for an IDI. Best picture I can find of it installed from this thread by towcat.
-
Free radiator if you qualify https://www.facebook.com/share/p/ee2SRKBAxA1MDvos/?mibextid=oFDknk
-
Update on the sterling swap. Only parts required are the Rough Stuff kit + a Moog 348 U-joint. I also ended up replacing most all of...
-
-
Loading…
-
Loading…
