zf 5 swap

[performancelaw]

I'm going to be doing the zf 5 swap in the next two weeks and getting rid of the junk e4od. I'm buying everything I think I need from someone. Just to be sure I get everything I need and don't have to make an unneeded 3.5 hour drive to get more parts from him. Can someone that has done the swap give me a complete list of what ill need. Also how hard it is to put the new pedal in etc .....

Thanks

 

[Tex_50613]

I can tell ya what all you need but don't know about the pedal cause I'm putting mine in a Chevy,
what you need from the doner truck,
the trans, the clutch pedal assembly, clutch master cylinder, clutch slave cylinder, the line between the master and slave, flywheel (I recommend having it re-surfaced), pressure plate (have it checked and re-surfaced), clutch disk (s), throwout bearing, possibly the trans cross member and drive shaft (s) but this I'm not sure about being as I'm putting mine in a 85 chevy and using a divorced np-205

 

[snaponprofile]

Yes, driveshafts and crossmember. You can't use pedals from a 83-91 truck, they must be OBS.

 

[dizdak]

bout time you get the truck back on the road!!!

 

[Diesel_brad]

Here is some reading material http://www.oilburners.net/forums/showthread.php?t=16973

When you do it, do a write-up so it can be put in the tech articles