Search results

  1. hce

    headliner

    Planning to pull headliner, replace the fabric,and add sound deadner . Any one know if an extended cab headliner will fit though the doors, would it be better to remove the rear window?
  2. hce

    Starts right up, runs rough, dies

    Was running just fine, let it sit for a couple weeks and starts acting up. Fires right off, run fine then gets rough and dies, about 20-30 seconds. Have to crank a bit to get to re-prime, runs fine once started again. Scenario will repeat if let sit for a couple of hours. If shut down for a...
  3. hce

    k1 kerosene

    Looking at a space heater and the manual says to use k1 kerosene, not farm fuel. Any one know the difference between k1 kerosene and #1 diesel fuel? Keep getting mixed results when looking. Some sources claim #1diesel is k1. Best description I have found is k1 is supposed to be low sulfur...
  4. hce

    A little different banks turbo

    Picked up a spare banks sidewinder turbo, and finally sent it off. Came back with a little different compressor wheel and a td06h center section. Adds some needed air to fuel. So far I like it.
  5. hce

    Will not turnover

    This goes with my post in the marketplace. Try the starter this morning, and turns over for a 1/2 second. Try the key again, click, press clutch try key click. Take backup vehicle to work. Start trouble shooting. Relay tested good. Crawl under.....
  6. hce

    Transmission adapter plate

    In need of the adapter plate between engine and manual transmission for a 6.9/7.3. I'll post pictures later as to why under the 6.9 section.
  7. hce

    Engine oil fill funnel

    Would like to see what other use for a funnel for the 45 degree engine oil fill. The best funnel I have found is 1 quart oil bottle with the bottom cut off. Is there a fancy funnel that will thread in?
  8. hce

    pesky rocker arm bolts

    Broke an exhuast rocker arm bot, driver side, week ago. Extracted the remains with a left hand drill bit. Today another one broke on the passenger side intake. Remains came out with a screwdriver. All the bolts were on the loose side, 15ftlbs. Not sure whats going on, all bolts were...
  9. hce

    One piece window

    Any body ever mess with a onepiecewindows.
  10. hce

    Exhaust restricive

    Thought I would share. Backed up a little to far to the pond today, while trying to play some pond hockey with the son. In my fun of unstucking the old girl the exhaust pulled off leaving an open down pipe. Once free of the mud, ice, a little throttle felt like a lot more. Felt like I was in...
  11. hce

    Hydrovac

    Looking for reputable place to have this rebuilt.
  12. hce

    self sealing r134a cans

    Got the pleasure of using the new self sealing 12oz r-134 cans. Is there a better adapter then the little blue crossthreading, snails pace filling, plastic adapter. Would prefer all brass that does away with the can piercing tap. May have to break down and keep a 30lb bottle one hand.
  13. hce

    Were does this go?

    Were does this bracket for the starter cable bolt on?
  14. hce

    d4 cat

    Looking for pop test specs for injectors on a 1952 d4 cat. s/n 7u17321. Thanks
  15. hce

    Are Fel pro head gasket graphite?

    Same as the title, are fel pro head gasket graphite?
  16. hce

    Hmmmmm

  17. hce

    Glow plugs

    What brand of glowplugs for a 6.5? Are they as finicky as fords?
  18. hce

    wtb: dana 50 pumpkin

    Any one want to part with Dana 50 ttb pumpkin with 3.54. Must have original dana/spicer gears, and willing to ship.
  19. hce

    pmd

    I know if I spent an hour serching I could find answers. Not a 6.5 guy. Looking for a PMD for a co worker. What the best one and where to get it?
  20. hce

    Vehicle diary page.

    Suggestion for site improvement. It would be handy if each user had a personal notes page to document vehicle specifics, same as the personal biography but for the vehicle. Notes that you do not want in your signature. Could be used for what part number hydroboost unit was installed, when I...
  21. hce

    Wheel balancer and now driveshafts

    Thought I would share pics of my contraption I use to balance wheels on the vehicle. Similar to the old on car strobe balancers, but a lot less money tied up. Also just tried it on my front driveshaft and its the smoothest its been and that is after 3 driveshafts from two places. With hubs in...
  22. hce

    banks wastegated compressor outlet temps

    Wanted to see if the often stated 300 plus degrees at 15 psi was true for the banks wastegated turbo. So I purchased a thermocoupler/meter and placed one thermocoupler in the intake hat. This is what I found so far. temperature outside was 40 boost psi temp F calculated density...
  23. hce

    wtb: worn out DMF

    Like the title says. Looking for a removed dual mass flywheel for a 7.3, loose and worn springs is fine.
  24. hce

    will it start tomorrow

    At my sons state hockey tournament 390 miles from home at a hotel no plug in, suppose to hit -20F. What are the bets on starting tomorrow.
  25. hce

    Any one near Nashua NH

    Anyone near Nashua NH that would be willing to pickup an ebay item and ship it. I would pay for shipping and packaging. Seller is not willing to ship item.

Latest posts

Forum statistics

Threads
91,314
Posts
1,130,179
Members
24,121
Latest member
720Diesel

Members online

Total: 642 (members: 8, guests: 634)

Share this page

Top