oil drain casting

[86F2506.9]

ok can some one give me like an all around picture of the oil drain casting it bolt on to the bottom of the turbo and goes to the valley pan im lookin to make one cause the one for my ats non waste gated turbo is missin send me pics plz dont care if u have ats or banks just as long as i know if it goes into the back of the intake manifold or no

 

[Dieselcrawler]

no it does not go into the back of the intake. there is a oring that seals off the hole on the wastegated setup. oring goes between intake hole and drain pedistal.

 

[dyoung14]

Looking at the one on my wastegated unit if there anywere close to the same i dont think you can make one, there cast

 

[sassyrel]

Looking at the one on my wastegated unit if there anywere close to the same i dont think you can make one, there cast

ummmmm, depends on your level of expertise--and tools available

 

[Devilish]

This the part you need?

 

[Dieselcrawler]

yeas it is. the ones u posted are off a banks set up, right?

 

[subway]

looks just like the one on my stock gated ats setup

 

[Devilish]

yeas it is. the ones u posted are off a banks set up, right?

ats 088

 

[dyoung14]

looks just like the one on my stock gated ats setup

similar the ones on our gated turbos run at an angle cause the turbo set off to the side on our setup