BP6.9
Full Access Member
my fuel hand is messed up, anybody got an idea of what could be wrong? i think its the float, it will show full for a second after i top it off but then it slowly sinks back down to E
fuel hand messed up
- Thread starter BP6.9
- Start date
Fordman75
Full Access Member
Sounds like a bad float on your sending unit.
Probably time for a new sending unit. Otherwise maybe a bad ground.
Probably time for a new sending unit. Otherwise maybe a bad ground.BP6.9
Full Access Member
well i checked all the grounds and they were good, i think its the float to
Dsl_Dog_Treat
I lost my face to the jaws of a poodle
The stock floats are a thin brass and over time will develop a hairline crack and they will fill up with fuel and sink to the bottom of the tank.
icanfixall
Official GMM hand model
I'm with all the above postings. Hopefully this is the front tank because that tank does not need to be dropped to remove the sending unit for repairs. the rear tank needs to be dropped or the bed removed to get the sending unit out. If it is the rear tank cut loose the fuel lines at the frame cross memmber or you will damage the lines and sender trying to drop the tank low enough to reach the disconnects. Been there and did that several times chasing a leak.
