Search results
-
rear brakes working a little TOO well now
Rebuilt the rear brakes on the chief. new hardware, wheel cylinders, shoes, drums, adjusters, parking brake cables. my problem is now with no load, the rears are trying to lock up on me. found out when a car in front of me chickened out on a yellow lights and i almost did a fish tail. Is the...- chickenpot
- Thread
- Replies: 19
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Parking brake lever pivot bolt
Ok got a question guys can anyone help me find a source for the bolt that the parking brake lever pivots on on the 10.25? Its a drw axle. Was doing brakes last night and i wanted to replace the wheel cylinders and all hardware etc, lube up the parking brake linkage.. Well i got one side out and...- chickenpot
- Thread
- Replies: 4
- Forum: 6.9L IH & 7.3L IDI Diesels
-
First run of the scrap metal Po' Boy Centrifuge
It's been a decent amount of trial and error but I found out what works and got everything in working order enough to run 5 gallons through last night. I'm pretty excited and hope everything holds up well to the many hours I plan on running this. In the end, was it worth it to build a fuge vs...- chickenpot
- Thread
- Replies: 0
- Forum: BioDiesel & Alternative Fuels
-
WTB Delphi IDI injector cores
set of 8 or whatever you got. offering $10 per- chickenpot
- Thread
- Replies: 0
- Forum: Wanted
-
Swap R&P or whole rear? SRW vs DRW?
So I have 2 10.25 rears, one is a 1993 dually with 4.10s and the other is a 1997 SRW parts truck with 3.55s. Does anyone know if its possible or feasible to just swap out the 4.10s with the 3.55? planning at the minimum to have to do a full setup on it, is there anything else that would be a...- chickenpot
- Thread
- Replies: 5
- Forum: 6.9L IH & 7.3L IDI Diesels
-
1994 F350 dash harness connector ID help
By chance, could anyone tell me what this connector is for? Did a complete dash harness swap into my 1993 F350. Donor harness came out of a 1994 F350, 4x4, and assumed auto trans because of the factory jumper across the clutch switch connector. Recipient truck is a 1993 f350 with the ZF5...- chickenpot
- Thread
- Replies: 16
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Belt driven fuel pump discussion
Hi everyone. Been lurking for a while after grabbing a 1991 f350 dually 5spd cab+chassis for pretty much the price of the drivetrain. Drove it home 3 hours. Anyway have a few good sources for clean WVO, want to run my truck on it. Little bit of background- I work as a food service equipment tech...- chickenpot
- Thread
- Replies: 36
- Forum: BioDiesel & Alternative Fuels
