Search results
-
zf5 swap no start
93 f350 7.3 I installed a fresh rebuilt 7.3 while I was at it I swapped out the e4od tranny with a zf5, I installed a factory manual steering column, I don't have no neutral safety switch hooked up and I removed the e4od wiring harness from the truck, everything seems to work when I turn the key...- haubert
- Thread
- Replies: 16
- Forum: 6.9L IH & 7.3L IDI Diesels
-
zf5 swap
I have a 93 7.3idi swapped out the e40d with a zf5 also installed the single mass flywheel clutch conversion kit. getting ready to instal the clutch brake assy. my question is im not sure if theres a particular slave cyl that I need for the single mass. I have a master cyl slave assy from a 91...- haubert
- Thread
- Replies: 18
- Forum: 6.9L IH & 7.3L IDI Diesels
-
E4od to 5 spd swap
I was at the scrap yard today looking for a 5 spd tranny looking to convert from my e4od. All I could find were older 4 spd what do you think of the 4 spd or should I hold out. I use the truck for heavy pulling are the final gears the same ratio- haubert
- Thread
- Replies: 6
- Forum: 6.9L IH & 7.3L IDI Diesels
-
What temp sensor
I installed a coolant temp sensor. I thought the sensor on the driver side front head is for guage. Installed probe hooked up guage and my in dash guage still works. Did I remove the wrong sensor or will the computer sensor reads to guage also Sent from my SCH-I545 using Tapatalk- haubert
- Thread
- Replies: 6
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Electric fan conversion help
I'm converting my cooling system over to electric, I have a new 3 core radiator ordered, I bought the 95-98 windstar fan assy, I didnot order the windstar control so I have no wire harness, any one have the part numbers for the pigtails one is a 2 wire other is 3 wire, I'm also assuming the...- haubert
- Thread
- Replies: 0
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Stock compression
Just checked my compression to see if its worthy of a turbo installation 93 7.3idi 280,000 on odometer, just bought the truck last year I don't know nothing about it motor warm lowest 400 high 450 seams almost to good for those miles anyone know what compression is from factory Sent from my...- haubert
- Thread
- Replies: 0
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Injector help
Bought a set of injectors for my 93 7.3idi , managed to get all but one out half were bb half e code most did not have the copper washer on, number two injector unscrewed and bottom sleeve is stuck inside, I managed to get the spring and needle out, I tried a hook pic, but its stuck, I would...- haubert
- Thread
- Replies: 0
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Carlisle Pa
Too cold to work in the garage, got a little time for a proper introduction, I have a 93 f350 crew cab dually 2WD 7.3 Idi with the e40d 280,000 miles bought the truck a year ago I didn't get any history with the truck, but it's not molested, body is good, not a spec of rust on the bottom side...- haubert
- Thread
- Replies: 3
- Forum: Introduction
-
b injectors
new to the forum and new to diesels, i bought a 93 f350 7.3 non turbo with e4od, dont know if anything has been done to motor 280,000 miles, bought to pull a 12,000 camper, truck runs fine, been slowly tune it up, installed k&n filter upgraded glow plugs and controller, just purchased a set of...- haubert
- Thread
- Replies: 8
- Forum: 6.9L IH & 7.3L IDI Diesels
