Search results

  1. L

    Its nice to be missed!

    I just got an email from oilburners saying that I hadn't been active in a while and that I was missed! My wife dont even tell me that! Lol. I sure haven't forgot about OB and all is well with my ole IDI! Bow season is less than a month away and I've been busy tending food plots, running trail...
  2. L

    Steering/Front end issue has me puzzled on my '93 F250 4x4

    Hey guys, I'm seeking some OB wisdom on an issue I'm having with my '93. This issue ONLY occurs after the truck has been driven for a little while and has had time for everything to be warmed up and even then it ONLY occurs when I'm turning the wheels slightly, if I turn them very sharp at all...
  3. L

    E4OD gets too hot

    I installed an Optishift controller in my '93 F250 last year. The optishift has a trans temp function and I began paying attention to it. When I'm just putting around town for short drives the trans temp is fine. If I take it for a decent drive, especially on the interstate or somewhere that I...
  4. L

    Sloppy Shifter

    The gear shifter on my '93 E4OD shifter on the steering column has become real sloppy. Is there some way to tighten it up up under the dash?
  5. L

    Timing question. I'm a little confused

    I finally got around to checking the timing on my IP. I replaced the injectors last summer and athough I had a used but in new condition Snap On MT480 meter complete with the lumey probe, I didn't check the timing at that time. I just advanced the timing until it sounded and felt right to me...
  6. L

    Banks turbo kit for C6 trans vs E4OD trans

    I'm looking at a used Banks turbo kit, its the older non wastegate kit. It came off of a 89 7.3 with a C6 trans. I would be putting it on my '93 IDI with an E4OD. It looks like it's possible that the up pipes won't fit the E4OD. Can any of you guys confirm if this is correct or not? If they...
  7. L

    Need some wire routing suggestions

    I'm in the process of installing my Optishift transmission controller. I already have the hot, ground, and TPS wires run for it. Now I need to run the harness for the solenoid plug on the passenger side of the transmission and the harness for the MLPS on the driver's side of then trans. Any...
  8. L

    Help diagnose my ignition/starter issue

    You can see what it does in the video when I try to start my truck. Goes clank clank clank a few times then starts. If I turn the key on then go under the hood and run a jumper wire from the batter to the starter relay, it fires right up with no clanks first. Is this a problem with my...
  9. L

    Banks Downpipes

    Just thought I'd pass this along for anyone who may be looking for a downpipe. I called Banks today to see if they still had any downpipes for IDI factory turbos. They guy said yeah I think we still have a few of those laying around. $125 shipped to my door.

Latest posts

Forum statistics

Threads
91,327
Posts
1,130,406
Members
24,133
Latest member
Nanohawk

Members online

Total: 753 (members: 10, guests: 743)

Share this page

Top