Search results

  1. 1

    driveshaft length

    ok im 85% done with the zf5 swap i just need to know how long the two piece factory drive shafts are on an extended cab pickup, mine looks like its 4.5 inches too short right now. so if anyone could grab the lengths for me id appreciate it
  2. 1

    clutch pedal

    im almost ready for my zf5 swap into the 92, does anyone know a good source near CT for a set of pedals? the set i got with the tranny were off an 89 so i dont believe they will fit. i also need to scrounge up a clutch alignment tool somewhere.
  3. 1

    5 speed swap

    i bought a zf5 for my truck to fix the problems ive been having with this e4od once and for all. im going to be buying a new dmf clutch kit for it, and resurfacing the dmf flywheel. should i do the rear main while ive got everything apart? it looks like it might be leaking alittle but not too...
  4. 1

    brakes

    im having a horrible time getting brakes in my truck. the line from the abs to the rear axle was blown when i bought it so i replaced that and the everything back brake wise except the drums. so then i bled everything, RR LR ABS RF LF and still no brakes. i continued to bleed until i had bled 2...
  5. 1

    78 cab

    will a 78 cab fit on my 1986 f250 frame? im looking for one to replace my new truck as its all rotted and i dont have a title to register it anyway. i found a cab with virtually no rust for 350, but im not sure if the cab was different then.
  6. 1

    need an injector line

    hello, working on the new 85 f250 6.9L idi today and i had to bleed out the air so i removed the hard injection lines and found out that the po cross threaded one so now i need one and was wondering where i could find one. its the one thats on the passenger side back 2nd cylinder in from the...
  7. 1

    e4od to c6

    hello, well i think im just about done with this dumb e4od transmission, i found a cheap used diesel C6 and was wondering how hard of a conversion it would be. i believe my 1356 transfer case would bolt up, im not sure about driveshaft length. also, how hard is it to plumb the vacuum modulator...
  8. 1

    TPS

    hello, in my ever-failing quest to get my e4od out of limp mode, i bought and installed a new TPS as the old one was reading 1.2v-4.0v instead of the 4.5v its supposed to read at WOT. however, after installing the new TPS i am getting the same readings. i even tried adjusting it all the way up...
  9. 1

    more e4od trouble

    hello, well i finally got my e4od to stop leaking, turns out it was the pump o ring. took it out for a test drive and it wont shift correctly. -cuss if i put the lever in the (D) range, it will start in first gear and not shift up to second. so i put the lever down one into 2 and itll shift...
  10. 1

    e4od leaking fluid

    hello, i recently purchased a used transmission for my 92 7.3 idi. the guy said it only had 30k on a rebuild but i dont know if hes telling the truth or not. ok so i put it up and it shifts great works lie it should, then i looked and saw it was leaking inbetween the motor and transmission. i...

Latest posts

Forum statistics

Threads
91,333
Posts
1,130,556
Members
24,137
Latest member
m2rtin

Members online

Total: 847 (members: 10, guests: 837)

Share this page

Top