Search results

  1. RyanDamo

    94 Dually Bed

    Up for sale is a dually bed off a 94 obs. The dually bed was converted off of the factory floor into a dually by centurion(same company that made the 4 door bronco. Therefore it is not an official dually bed but is in no way shape or form a hack job. It is reletively rust free with the...
  2. RyanDamo

    IDI PARTS

    y pipe off of 4x2 idi y pipe off 4x4 idi 30$ a piece 50 for both box of 6 7.3 style fuel filters $30 7.3 glow plug controler, unaware of operation condition $20 Dana 60 dually hubs off of a 92. come with wheel...
  3. RyanDamo

    6.9T and other parts for sale

    Make offers 86 6.9 124k miles engine with new carrier lift pump and accessories $400 Copper Radiator with hoses $50 4x2 t-19 make offer complete hypermax kit, turbo has bad oil seal $400 3.5 exhaust $50 86 10.25 DRW axle 100 86 interior...
  4. RyanDamo

    dually hubs 1992 dana 60

    dually hubs off 1992 dana 60, one stud is bent from falling off shelf, comes with the wheel bearings that were in it, and the red manual locking hubs. 200$ will not ship!
  5. RyanDamo

    1986 F350 6.9 w hypermax

    1986 f350, cab and chassis with a iron and wood flat bed. 6.9 idi t19 2wd truck it runs and drives. has 124k with all service records. Have title. smokes on start up. I bought it and never registered it although i have driven with it around locally hauling firewood down the street. Its road...
  6. RyanDamo

    garrett turbo rebuild

    Hey guys, i was just wondering if anyone could point me into the right direction as to what model turbo this is and where i can obtain a rebuild kit for it, it is blowing a little oil out into the exhaust housing very slowly. it is a garrett serial RK0109 L 409900-5001 is the number...
  7. RyanDamo

    dana 50 ttb axle

    Got a 94 dana 50 twin traction front axle. Has 4.10s gears and 83k miles. hubs and steering links are not included, rather see it go to a good home than scrap it. ;Sweet
  8. RyanDamo

    Dana 60 Dually Hubs

    Got a set of Dana 60 dually hubs off of a 92, one of the wheels studs is bent from falling off of the bench, wheel bearings inside still seem to be good $150
  9. RyanDamo

    1997 F250 HD Crew cab Shortbed

    1997 F250 HD Crew cab Shortbed 1997 F250 HD Crew cab Shortbed 7.3 Powerstroke XLT loaded with exception of power mirrors. 40/20/40 seats in front with power lumbar, bench seat in back. Interior is clean with no flaws. remote entry with factory "alarm", rear windows tinted, a/c blows cold...
  10. RyanDamo

    water seperator wiring

    I swapped the original water separator out on my 86 and installed the later model water seperator on it that doubles as the fuel filter. my question is, there where 3 wires that plugged in to the top of the original on on the firewall. Which wires to i wire into the new one to make it work.
  11. RyanDamo

    94 Dana 50

    I did a dana 60 swap on my truck a few years back, saved the old ttb axle, has 4.10s in it, 83k miles, no hubs or bearings, ball joints were good. comes with steering rods and tie rod ends. if anyone in the area of CT can find some use for it come get it 50$ Comes with brand new in the...
  12. RyanDamo

    starter bolt sizes

    What sizes are used on the 6.9 starter. I destroyed mine getting the old starter off, someone torqued them on good. -cuss
  13. RyanDamo

    f350 front driveshaft yoke

    Does anyone know the size of the bolt holding the front driveshaft yoke to the transfer case on a 93 f350, Im switching to the double cardan joint driveshaft that a local pick and pull has in the lot.
  14. RyanDamo

    psd turbo

    I was wondering what is involved in adding a powerstroke turbo to an idi. I remember reading that is been done before and i was wondering what kinds of fabrication is involved. I picked one up today at the junkyard as it was sitting on the drivers seat of a powerstroke van ;Sweet
  15. RyanDamo

    Bushing Question

    Does anyone know if the bushing for the twin traction beam axle on a f250 4x4 are the same as the bushings on the twin I beam found on the 4x2 trucks. I have a set of the 4x4 bushings lying around but i did a dana 60 swap and want to know if they will fit my 2wd truck.
  16. RyanDamo

    Blue Gauges in an OBS truck

    Hey guys, i did this write up over ar powerstroke.org so ill share it with you guys too, this works for any 92-97 ford truck and it turns the factory gauge color blue Hey guys, Im not sure if this has been done before but i remember reading an article that the superdutys can have their gauge...
  17. RyanDamo

    electrical problems

    does anyone know where i can locate a wiring diagram for the headlight switch in my 86 f350. my headlights work fine, but when i pull the switch half way out, the dash doesn't light up, neither do the park lights. i want to to jump the wires before buying a new switch. ALSO When are the...
  18. RyanDamo

    7.3 fuel filter/seperator

    So i went to the junkyard today and picked up a fuel filter housing off a 91 idi. its seems like a straight forward swap except for wiring the water in fuel light. Im confused as to which wires go where. Also it appears that there is some sort of sensor on it similar to the filter restriction...
  19. RyanDamo

    y pipe question

    Hello everyone, I purchased a 1986 6.9 2wd flatbed dually a month ago with the exhaust rotted out. I Got a full 3.5 inch exhaust off of a 95 powerstroke van from the junkyard and im almost done but i ran into a little snag . I thought the factory y pipe turned into 2.5 inchs after the 2 pipes...
  20. RyanDamo

    2wd leveling kit

    Hey guys, i have a 97 f250 crew cab short bed powerstroke thats 2wd. I was wondering who makes a leveling kit for the 2wd trucks. I cant seem to find any anywhere
  21. RyanDamo

    a few questions about the ford sterling 10.25

    Hey guys, i have a few questions about the for 10.25 axle. First, on my 1986 f350 dually. i changed the hub seal today and was reading the haynes manual and is said pack the bearing with grease. now i know its a full floating axle and the the gear oil lubes the bearing so is that statement...
  22. RyanDamo

    Question about plows

    Hey guys i was wondering if a plow off of a 96 f150 with a 351 4x4 would fit a 86 f350 2x4 with a 6.9 diesel -OR- a 94 f250 4x4 with a powerstroke. are the frames the same width apart?

Latest posts

Forum statistics

Threads
91,330
Posts
1,130,465
Members
24,133
Latest member
Nanohawk

Members online

Total: 704 (members: 10, guests: 694)

Share this page

Top