u2slow's latest activity
-
u2slow replied to the thread Highboy Axle Swap.My understanding of the f250 4x4 dentsides is the 77-older have narrow frames (34") and ~40" perch spacing. (Aka 'highboys') 77.5+ have... -
u2slow replied to the thread Highboy Axle Swap.How about using the C&C sterling? They have 40" perches...
-
u2slow replied to the thread Glow plug amp draw.I also seem to remember it being higher... more like ~15A per GP.
-
I think you guys are way low. I seem to remember someone on here long ago did some testing and all of them together was a good bit over...
-
u2slow replied to the thread 1995 12 valve headgasket leak.Mine leaked the same way. Ordered up an "engine tech" gasket set from rockauto, and got new head bolts from fastenal. Lo and behold...
-
u2slow replied to the thread Parking brake lever pivot bolt.I have used a basic 1/4"-20 nut/bolt before. Gets the job done.
-
u2slow replied to the thread 92 f250 idi - i beam lift? 2wd....The f250 4x4 doesnt have a solid axle. Its the twin-traction beam. Shorter beams than a 2wd. The 2wd beam setup is similar for...
-
That sounds like me except mine are ford with the exception of 3 chevys . James
-
u2slow replied to the thread 3.07 diffs & np435?.LOLLOL I'm literally swimming in dodges. Its more a regime to marry up the best of 2 incomplete trucks so i can scrap one and free up...
-
u2slow replied to the thread U joint troubles.I can always get at ujoint strap bolts with a socket and wobble extension. Might have to clock the shaft around for better angle though...
-
u2slow replied to the thread U joint troubles.Are the little ujoint cap 'stopper nubs' still in the yoke? If not, the caps will work themselves out. Is there fore/aft endplay in the...
-
u2slow replied to the thread 3.07 diffs & np435?.Impressed to hear you managed 2.56 in a truck with an auto - and not be useless! I'd have been concerned with how much heat/slip happens...
-
Not apples to apples, but my dad and I have owned a 2:56 geared C10 mild 355/TH350 (low stall) for almost 30 years. 29” tires...
-
u2slow replied to the thread 3.07 diffs & np435?.That part I'm confident will be fine. I had a suburban I geared to 3.21 with the Sm465. (6.2 diesel though). 1st gear was most often...
-
I'm working on this swap now. Had a 2005 2wd f250 that I pulled the rear axle and all of the brackets off of (radius arm, coil buckets...
