Recent content by OREGON KID
-
Axle swap brake issue
I just swapped in. A new master cylinder and cured the issue.....im guessing after 1+ years of being open (brake line ends in plastic bags) the master dried out ... Replaced with complete master/booster and now solid brakes .... Thank you all for the guidance and advice- OREGON KID
- Post #10
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Ats turbo
Hey .....so i installed a used ats .093 turbo and have a question....is there supposed to be a gasket inbetween the exhaust housing and and exhaust connection flange- OREGON KID
- Thread
- Replies: 1
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Axle swap brake issue
Its hydro and when its off i have 90% power....but as soon as i start the truck its straight to the floor.....would i need to update the master cylinder?? As far as installing a proportioning valve it has rear abs so where would i tap one in.??? Do away with the rear abs ?? I wont haul much and...- OREGON KID
- Post #5
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Axle swap brake issue
Hey guys ..... So i swaped in front and rear 03 axles and brakes from an 250 into my 93 ...i cant figure out this issue. Truck is off and brake pedal is 90%.... Then i start it and its a complete loss of all preasure.....all new calipers,rotors and lines...hard and soft have been swapped for...- OREGON KID
- Thread
- Replies: 11
- Forum: 6.9L IH & 7.3L IDI Diesels
-
7.3 idi instrument cluster question
Thank you that is exactly what i have been looking for.....- OREGON KID
- Post #3
- Forum: 6.9L IH & 7.3L IDI Diesels
-
7.3 idi instrument cluster question
Hi guys .....i have a 92 f250 7.3 idi and i need to find out a flashing bulb issue from the cluster.....its the 3 bulb on the lower left indicator section....(the platic lens over the turn signal part is gone on mine and trying to find the correct bezel has proven damn near impossible.)..thanks...- OREGON KID
- Thread
- Replies: 3
- Forum: 6.9L IH & 7.3L IDI Diesels
