If transfer case is not on the transmission that is fine. Just make sure transmission is in gear to turn the input shaft while turning the output shaft.
I tried to add to my post but it doesn't look like it took. I am wondering about the throwout bearing still being in the correct location. It might have come loose and dropped onto the input shaft blocking the tranny from sliding to the motor. WAG.
How far apart are the tranny and the motor?
May be a dumb question, but have you tried sliding the clutch onto the tranny input shaft. ( Would have to remove clutch from flywheel )
Lots of good info from Big Bart. I have had vibration issues with u-joints that had zero play. Could find no other causes so took out the u-joints and upon inspection were bad. Replaced and no more vibration.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.