Thanks Vegas
I thought about that but I was afraid the stud was cast into the gear housing; and didn't want to chance it. I am very glad to know that; I'll probably go back that way. ........Mike........
Thanks for your help. I was able remove IP.
I opened the hard line clamp on the passenger side and removed the lowest line from the IP. That allowed me to raise the pump and lines over manifold
on driver side of the intake.
In process of removing IP as per helpful article by Mel.
Encountered many minor problems, < it's a van> . I found I had a major hangup.
I cannot raise the pump flange end up because top stud overhangs pump housing and flange..can't raise pump rear end because VAN cowl
will not allow...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.