mf7lakes's latest activity
-
mf7lakes replied to the thread how much time before 7.3 is warm? outside temp now 10*C. -
-
Ok for stationary equipment. They place a lot of stress on the terminal. I would do a junction block for the extra take offs.
-
mf7lakes replied to the thread Charging question.Any of you guys ever used a battery terminal like this ------>
-
-
https://classicdieseldesigns.com/products/7-3-6-9-idi-oem-replacement-battery-cables...
-
Do a voltage drop test under load and it will tell you what is going on. Cheep drop test, put it under load for a few seconds such as...
-
Classic diesel designs has a set on his site.
-
mf7lakes replied to the thread Charging question.Do you guys know who might sell quality pre-made-to-fit cables if it comes to that ?
-
mf7lakes replied to the thread Charging question.Hmmm -- I'll get exact readings after 2nd cup but, amazingly for me, I did test ohms yesterday -- meter tested at zero ohms but red wire...
-
If the batteries load test OK, I agree with Clb in that there's something going on inside the wire insulation. Good luck, wiring stuff...
-
The original wires have a really cool way of looking just fine but having a ton of green corrosion inside the end of the wire right next...
-
Testing to see if the wire has resistance... If the internal resistance is high due to corruption of any sort, it wont flow power as...
-
mf7lakes replied to the thread Charging question.Both batteries test very good, separately & with no leads attached -- leads are clean/solid -- well, I think if you separate the...
-
When engine is running, pax side battery shows it is receiving 14.4 volts when measured between the posts. Driver's side battery shows...
-
mf7lakes replied to the thread Reman engine source.https://www.promarengine.com/engine-details.php?pn=IN7.3-01&year=1990&make=Ford&model=F-350&submodel=Custom
-
mf7lakes replied to the thread Clutch hitting safety switch.And cannibals..... don't forget the cannibals
Latest posts
-
-
-
-
-
“Need help using my DTI 3300s timing meter on my 6.9 IDI.”- Latest: WrenchWhore