Recent content by bigmike
-
B
cold start vibration
I have a 96 f250 auto that makes a vibration noise when it is started cold but noise goes away when it is warmed up. Any ideas?- bigmike
- Thread
- Replies: 6
- Forum: 7.3L Powerstroke Diesels
-
B
banks parts
I have heard that they do sell the high ram intake by it self.- bigmike
- Post #3
- Forum: 5.9L 24 valve Cummins
-
B
plug for lift pump
need pigtail Ok I did need the pig tail. the plug on my old lp is on the top and it is on the bottom of the new style lp. Anybody got a part # and where to purchase the pigtail.- bigmike
- Post #6
- Forum: 5.9L 24 valve Cummins
-
B
plug for lift pump
just purchased a lift pump off a 01 for my 98.5 is the wireing the same or do I need a adapter- bigmike
- Thread
- Replies: 6
- Forum: 5.9L 24 valve Cummins
-
B
Electrical problem
I am working on an o1 f250 diesel that has a problem with the wireing harness for the tail lights goimg on and off and going dim.You can move the wires and the problem will stop. Any ideas or any recalls?- bigmike
- Thread
- Replies: 2
- Forum: 7.3L Powerstroke Diesels
-
B
285's on dually
Wher did you get the spacers and how much did they cost. I would still like to see some pics if you know where any are.- bigmike
- Post #4
- Forum: 5.9L 24 valve Cummins
-
B
cummins lift pump #
What is the correct part # for lift pump from cummins and how much?- bigmike
- Thread
- Replies: 6
- Forum: 5.9L 24 valve Cummins
-
B
285's on dually
Anybody got 285/75/16 tires on their dually and did you have to use spacers on the rear. Also post some pics if you got them.- bigmike
- Thread
- Replies: 3
- Forum: 5.9L 24 valve Cummins
-
B
Cruise no worky!
there is a vacum line that runs under the drivers side battery that slides together ,find it and trace it out and check all vacum conections- bigmike
- Post #4
- Forum: 5.9L 24 valve Cummins
-
B
lift pump question
installed fuel pressure gauge to my stock 98.5 today. My gauge is on the pre filter side and i am getting 10 psi at idle and 5 at wot. Is this ok or is it time for a lift pump?- bigmike
- Thread
- Replies: 8
- Forum: 5.9L 24 valve Cummins
-
B
tranny problems
I am havig problems with my 98.5 five speed going into second and reverse. I had this same problem 8 months ago. I replaced the clutch maser cylinder and still same problem. Mechanic says slave cylider is good. I replaced the clutch and the problem was fixed.12000 miles later the problem is...- bigmike
- Thread
- Replies: 0
- Forum: 5.9L 24 valve Cummins
-
B
blower motor problems
I loose power to the heating and cooling switches on my 98 dodge when i turn the steering wheel to the left and regain power when it is turned bak to the left ,. any ideas ?- bigmike
- Thread
- Replies: 1
- Forum: 5.9L 24 valve Cummins
-
B
blower motor on dodge
Blower motor on my 98.5 dodge cuts off when steering wheel is turned to the left,and comes back on when turned back right. Power is lost to heat and cooling switches as well . Any Ideas?- bigmike
- Thread
- Replies: 2
- Forum: General, Performance Upgrades & Accessories
