I have called several auto parts stores in regards to replacing my pick up tubes in my fuel tanks. They all are telling me there is no such a thing. So how do I repair my tubes. Just clamp a piece of hose onto it? I haven't taken them apart yet as I am still driving the truck. Either way, how...
You really really REALLY need to get those junk gps out of your truck!!!!!!! Wait on them if you order them. You are really asking for some serious headaches!!! I am pretty sure you are going to be ok, but get those things out of there!
I was referring to the isuzu engine you were describing. Those engines would come in the little white flat nose trucks right? I tried researching the isuzu applications, but to no avail. I will just have to keep asking questions.
Just a little pointer for you. That new flywheel is going to be heavy. The bolt pattern on the crankshaft does not make a complete circle. Get some all thread the same size as the flywheel bolts, at least 2. Put one by the gap, or missing bolt hole on the crankshaft. Put the other one...
Well crap....that is not good news. I already have a rebuilt oil-cooler waiting to get installed...LOL That was the easiest part of your whole post! LOL Can I just jack the cab up a few inches? Use a cherry picker or a hoist to lift the motor high enough? Would it be easier to do this with...
My '05 dually has a 3.73 LS with disc. It is a 4WD truck. What year ranges are inter-changeable? I found an '02 dually 3.73 LS with drum, can I swap my disc brakes onto that? What is the difference? My axle tube has separated from the pumpkin housing. I have been told my 2 differential...
Well, I checked and there is no oil on the clutch. The oil pan is leaking I am going to need to remove it and reseal it. I am not looking forward to that. The slave cylinder is operating correctly. As is the throwout bearing. There is no binding at all. I pulled my gooseneck dump trailer...
Yes I even read the disk. I do appreciate you asking. I torqued to to 20lbs. I am going to just see how bad that oil leak is. I will get some brake clean and have a buddy push in the clutch. Spray it and clean it and see if that changes things up a bit.
That is about right. Clutch pedal feels good. In first it is almost immediate grab from the floor. I usually take off in second and the travel you mentioned is about right.
No, I installed a new "luk" single mass. I do have an oil leak. I have been watching it, the flywheel seems very clean still. I replaced the rear main oil seal. I see no leaking from it. I will inspect it closer. When I installed the clutch it was clean, it went from the plastic to the...
Where in the world can a guy even find one? I am curiously contemplating putting a 4bt in my '66 slick. It is a 2wd shortwide. Would that be a good marriage? I would obviously trash the 3 on the tree, I would prefer to stay with a manual transmission. It would obviously need power steering...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.