I've got something that looks like it could be a muffler. You can see through it. I'll try it for a while. I think it's 4". It was like new. May be the only part that actually goes back on the truck.
Been debating which radio to put in mine. I have a uniden that looks a lot like that and a cobra 40 channel. Same form factor. What are you doing for an antennae?
Neat, so how flexible is the signal splitter? I have a sensor on my flywheel I would like to set up to feed my tack.I'll try to document stuff for ya then Mike. I'm going to try and use the RABS sensor for the speed signal.
My rear axle that is from a 91 has a port for one. The number of teeth on the tone ring give me too many pulses per mile tho. So I'll add this pulse divider which should bring me back in range of the new CC module.
If I can't get this to work, I'll fall back to putting a VSS on the end of the speedo cable. But that means a new speedo cable, and a RPITA to swap on my set up.
You must be registered for see images attach
how flexible is the signal splitter?