After mowing a lot of grass tonight, I fit my gauge pod to the dash.
It's not perfect but it's not too bad. I've been trying to figure out how to mount it securely without driving screws into the dash. So this is what I came up with.
Thin piece of steel fit into the bottom. Then I drilled and tapped the holes for the 10-32 black screws that I cut down to just through the metal. There is still a lip around there so I think a couple pieces of good double sided tape and I'll be in business. Take screws out and I can get to the inside then screw it back down. I think it will pull down tight.
You must be registered for see images attach
It's not perfect but it's not too bad. I've been trying to figure out how to mount it securely without driving screws into the dash. So this is what I came up with.
You must be registered for see images attach
Thin piece of steel fit into the bottom. Then I drilled and tapped the holes for the 10-32 black screws that I cut down to just through the metal. There is still a lip around there so I think a couple pieces of good double sided tape and I'll be in business. Take screws out and I can get to the inside then screw it back down. I think it will pull down tight.
You must be registered for see images attach