asmith
Full Access Member
Thank you for all the replies. I know the basic steps for doing the procedure. i just have no way of cutting threads for the heim joint. also i figured you would probably want to make the rod somewhat adjustable to get the throw just right.
Kawamatt the bushing where the lever meets the rod in that picture looks a lot beefier than what is in mine. Is it plastic?
Lots of good ideas in this thread and if no one wants to make a little money i will look into doing it myself.
just out of curiosity can the bushings on the main cross bar that all of the pedals are attached to, be changed without removing the assembly from the truck?
Kawamatt the bushing where the lever meets the rod in that picture looks a lot beefier than what is in mine. Is it plastic?
Lots of good ideas in this thread and if no one wants to make a little money i will look into doing it myself.
just out of curiosity can the bushings on the main cross bar that all of the pedals are attached to, be changed without removing the assembly from the truck?