I got a 2000 psd and my buddy has a 97 they both won't rev up after starting when it is cold.When it is down around zero it will start and you can hold the pedal to the floor but it does nothing. It is not the ebp, once it runs for a while then you can get the rpms to build slowly. Any ideas...
Will a leaking manifold gasket cause higher exhaust temps? My buddy is having problems all the sudden with exhaust temps the only thing we can think of is the exhaust leak
Where is the best and cheapest place to get a new pcm.I think my loose chip finely fired the computer,is there any way to tell for sure other than the fact it won't start.:mad:
I was backing the 7.3 out of the garage today and the clutch pedal went to the floor and will not release. What should I look for if it is the slave cylinder how do you get it out of the transmission?
Will an auto tranny with overdrive out of a f250 gasser work ok in a 6.9 without overdrive? Is one heavier duty that the other or the same?
Whitestroker and I have a chance to buy an old parts truck that has been sitting for a couple years(?) that is supposed to have a rebuilt tranny and...
This morning at -5* started up the 7.3 everything seemed fine for starting it with no block heater left to make a pickup and started smelling fuel not getting to worried yet but on the way back the clutch starts to slip.
So when I get back and start investigating the rubber seal on the fuel...
With the glow plugs all working how cold will the 6.9s start without being plugged in?
The powerstroke I never had to plug in But I am sure this one is a little different.
does anyone know if there is some type of helper springs for the front?
It really needs some help with the plow on the front even without the plow she really sags.:(
If the front leaf springs off a 2000 f250 will fit on a 1986 f250?
I got a set of spring from when I put in the leveling kit thought it would help the 86 a little see how it is almost hitting the rubber stops.
Some idiot took the breather tubes out of the filler necks when the mounted the flat bed. Now neither tank takes fuel unless you pull the litlle plug deal out of the top of the tank. So where can you get new breather tubes or what can you use instead? cookoo
Well this weekend I fixed the sag on the right rear corner of the 6.9. I found it to have the top three leaves broke right out the centering pin. but the question I have is what for bolt do you use for the rear leaf spring hanger had to cut the one to get it. We just put a Gr5 1/2 bolt in for...
Ok I just changed the y pipe, should I run the exhaust out the back, side , or a single stack. The guy who built the bed has a hole cut in the bed for stacks. We turned the pump up 5 flats so we have some smoke even with the b 100. Diezel cowboy is really pushing for the single stack. The...
Ok I need to know is there a way to pull start a auto transmission truck?
I heard if you pull it over 35mph that it will build enough pressure to turn ther motor over. Anyone ever done it or tried it?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.