Windshield washers didn't work when I got this truck, sprayer nozzle was snapped off. I put some adhesive heat shrink on it to attach the hose which worked fine for a few years until my Texas trip. The adhesive melted and I lost washers.... I had bought a new sprayer nozzle from Bronco Graveyard and then my pump died. I never did get the sprayer nozzle working.
I bit the bullet and bought a new washer reservoir with pump. Had crap luck with trying to replace the old pump and brittle 30+ year old plastic. Worst part of the whole job was paying $20 for shipping
I don't know how close it is to the hood. It seems to clear but I'll know better after a little while driving. Holds a full gallon of fluid which I wanted. They do have smaller ones available as well. This is the one I used, your results may vary.
The new bottle ALMOST lined up with the existing bolts. I forced it a little bit and it popped on and I was able to tighten up the stock hardware with no modifications.
I already had the wiring pigtail for another project, but that was the only modification required for this. You could always just crimp on spade connectors if you wanted to.
I found a bunch of gunk in the sprayer nozzle. No clue how that happened. Probably what killed the old pump. Cleaned it out and IT WORKS NOW!!!
Very happy to finally have functional washers again after years without!
Washer reservoir with pump
https://www.usplastic.com/catalog/item.aspx?itemid=117553&catid=934
Pigtail I used for sale on Amazon
https://a.co/d/j6LrZPH
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
I may do a write up after a little bit of running it to make sure there aren't any clearance issues that pop up. It is sitting on the inner fender which could become an issue down the road.
Also found this wire I hadn't noticed before. I'll have to figure that out at some point....
You must be registered for see images attach