-
-
catbird7 replied to the thread Installing engine and trans together..I've pulled two and installed one. Every occasion engine and trans were still bolted together, core support removed. One key piece of... -
catbird7 replied to the thread DRW to SRW Pros cons discussion.If it was originally a single rear (typical pick-up), the "dually conversion" must be simply a set of wheel spacers allowing the duals...
-
Well I took a closer look at this today. I pulled that cover and looked around with an inspection camera, and there was some stuff at...
-
catbird7 reacted to Greenie's post in the thread Another good reason to stay out of Calif. with
Like.
Back in the 1950's diesel trucks often belched black smoke to the point of sooting up the trailer the tractor was towing. Since then... -
Screwsome is the devil and everyone in Capitol Dome are his minnions... There is a ground swell of red out there this year. So fingers...
-
https://www.oilburners.net/threads/new-up-pipes.85459/page-4#post-1130599...
-
200?HA! Hold my beer! In Commiefornia for my 1986 f250 they wanted 400 bucks a year! Here's the trick, put my lance camper on and went...
-
catbird7 replied to the thread So what did you do with your truck today?.@IDIoit sounds like you're the man! Do you have photos of your up pipe and price? Do you have a website?
-
@IDIoit makes a banger of an up pipe that does away with the slip. I have one. Best purchase ever.
-
catbird7 replied to the thread So what did you do with your truck today?.Not certain if it was coincidence or not however just recently replaced injectors and within couple days two glow plugs died. Replaced...
-
-
catbird7 replied to the thread What years f250 idi diesels had limited slip?.I have an 87 that's open and an 89 limited slip. (both idi diesel Sterling axles and both are 4.10). I can take a pic of the 89 tag if...
-
catbird7 replied to the thread Highboy Axle Swap.No signs of previous repairs. Actually, the spindle portion where the bearing and race are located are still in place in the brake drum...
-
catbird7 replied to the thread Highboy Axle Swap.Sterling swap kit from Rough Stuff is "beefy", however while it's not installed yet I have discovered the highboy blocks will require...
-
-
catbird7 replied to the thread Highboy Axle Swap.Pics of failed dana 60. What it should look like vs snapped off.
-
-
-
Loading…
-
Loading…
