Latest activity
-
JJackson Fronsdahl replied to the thread Dead 7.3 IDI Diagnosis.Will do all of this after work! Thank you, I appreciate all the advice. Keeping me from taking this truck into the woods and blowing it...
-
Ggardog808 replied to the thread Power glow plugs thru a switch straight from the battery?.I’ve found there’s a few places you can stand/squat safely inside the engine bay, rather than squirming around on your belly over the...
-
Jesus Freak reacted to ROCK HARVEY's post in the thread Headlamp relay harness update or improvement. with
Like.
I think this is an upgrade everyone should do. There are some really good instructions online so it’s not hard at all to build your own... -
Jesus Freak reacted to IDIBRONCO's post in the thread Headlamp relay harness update or improvement. with Like.
I installed two harnesses from LMC Truck (probably the same as the ones from Bronco Graveyard) into my two Bull Nose trucks. Since I...
-
DaveBen reacted to ROCK HARVEY's post in the thread Headlamp relay harness update or improvement. with Like.
I think this is an upgrade everyone should do. There are some really good instructions online so it’s not hard at all to build your own... -
ROCK HARVEY replied to the thread Headlamp relay harness update or improvement..I think this is an upgrade everyone should do. There are some really good instructions online so it’s not hard at all to build your own... -
Ggardog808 replied to the thread how to turn up boost on factory turbo 7.3 idi.i always thought the longer rod would open the waste gate sooner thus decreasing turbo boost potential?
-
I'd guess battery cables here. One end may be loose and you haven't noticed it yet. Maybe it's the engine end of a ground cable.
-
YJMike92 replied to the thread 7.3 PSD intercooler measurements to fit 1986 f250.I have used a 6.0L in the past. I bought at a local salvage yard. -
Jesus Freak replied to the thread Dead 7.3 IDI Diagnosis.Turn the key to the on position, then go to the engine and unplug the connector on top of the injector pump and plug it in a couple...
-
Olds64 replied to the thread Throttle Cable Receiver Connection keeps "Popping Off" of the Injection Pump Arm.You could check Summit Racing and Jegs for cable ends and ball studs. Maybe you could remove the OE ball from the throttle arm and... -
So, I think ive got it figured out. Previous owner did the classic “farm fixes” and did some jank wiring, cleaned up the wiring a bit...
-
Aasmith replied to the thread Dead 7.3 IDI Diagnosis.You can try and check the resistance in the main battery cables. I dont know what the max resistance that is allowed, but I would want...
-
JJackson Fronsdahl replied to the thread Dead 7.3 IDI Diagnosis.At this point I'm not sure, there's likely more then one issue. I checked and cleaned the big gray connector, the fuel shutoff solenoid...
-
JJackson Fronsdahl replied to the thread Dead 7.3 IDI Diagnosis.Yea, idk at this point. I checked and cleaned the big gray connector, the fuel shutoff solenoid connector, and the battery terminals...
