Hi guys, I've been reading the forum here for a while and everyone has been so helpful, so thanks in advance but I think I have a situation that I haven't encountered in any threads so far.
After sitting for a few days my 94 7.3 turbo idi did not want to start after a ton of cranking. Ended up...
If you have an IDI block you can make it into an IDIT easily. The blocks are the same. Only the rods, wrist pins and pistons are specific to the turbo. I'm not sure about the crank. Both have under-piston oil cooling. There are stories on the internet about webbing in the casting being...
Looking for some help. I stockpiled turbo parts for a while looking to turbo my 92 idi. Have all of my piping and everything else. I’m lacking a turbine shaft and wheel. Due to the fact I had to destroy it trying to save the hot side housing. I have mic’d and measured the shaft and wheel just...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.