f350

  1. S

    FS 1985 F350 AND PARTS SCLB SRW 4X4 4SPD 7.3 IDI

    Asking $5,000 for truck and parts Hey, I'm located in Vancouver, WA, USA. I'm new to the forum, but I have a running driving 1985 F350 for sale. It's a single cab long bed single rear wheel 4 speed manual (solid axles front and rear) truck. Original 6.9, the truck had a remanned 7.3 IDI swapped...
  2. B

    What to look for in a truck that's been lifted?

    Howdy y'all! I hope to be joining the idi club soon! I'm going to look at a '90 f-350 (single, not dually) 4x4 with a zf5. I've been cruising the forum, and I think I have I good idea of what to pay attention to when looking at an idi truck. But I was thrown a curve ball when I was told it has...
  3. Lyrik

    Belt Eater

    Hey everyone! I am hoping to find some answers to help me iron out some of the issues with my truck. She is my first diesel so please forgive my naïveté and bare with me. My truck is a 1993 F-350 Ambulance Package, former animal control unit for the Las Vegas, NV police. It is a 7.3 IDI...
  4. D

    08 axle in 1993 f350

    So I'm putting a 2008 f250 axle into a 1993 f350. I know the axle should just bolt up my question is what adapter will I need for the brake lines and what master cylinder should I use.
  5. Kraig

    Odd hum from front end

    Hey all, I have a 95 f350 4x4 7.3 manual. I have a weird hum sound coming from the front end. Weird part, it quiets when I slight turn the wheel to the right. It will sing when you slightly turn the wheel to the left. Once you then the wheel slight to the left it gets quiet and you really hear...
  6. foundonroaddead

    1992 Ford F-350 7.3 IDI NA drives 1/2 mile then dies and has hard starts...

    Hi all, I recently began working on my dad’s old 7.3 IDI in mid November since my LB7 Duramax has faulty injectors (again). It’s been sitting since 2008 so I’ve done a decent amount of maintenance on it so far. I’ve replaced batteries, return lines, injector orings, oil, transmission fluid...
  7. Caleb M Hughes

    Dual rear wheel axle with single rear wheel?

    So my trusty 94 F350 DRW (sig. truck) scalped a tire today, and the other three are so-so and mismatched so I'm in need of a solution, with winter coming in North Dakota real soon I'm debating put a locally sourced set of Aluminum wheels from a 95 F350 single rear wheel truck, my truck is 2WD...
  8. ComatoseLlama

    My truck gets a new life - engine swap build thread

    Huge score today, picked up a good running 7.3, C6(?) and a 203 transfer case. Came with a new DMF flywheel and clutch kit, 7 spare injectors, core support and firewall forward engine harness, starter and a full A/C system. Got it for a song. Low-ish milage Guy just torched and cut and lifted...
  9. stick_witch

    7.3 idi compression test numbers and discussion

    Hey guys! I just did a compression test on my truck while I have it torn apart. New to these motors and diesels in general so if anyone could shine some light on this topic that would be great. Results: 380psi @ 21 compression strokes 380 @ 21 340 @ 21 340 @ 21 380 @ 21 295 @ 21 440 @ 21 420...
  10. N

    Wire routing for EGT sender.

    Need to run some wires through the firewall, for EGT and oil pressure gauges. There is no boot around the steering column, and the small grommeted hole behind the clutch pedal is already filled with who knows what. I don't have a radio, so I was thinking of putting the wires through the...
  11. Northern Red

    E40d to ZF5 conversion parking brake?

    So, I might be totally out to lunch on this, but it’s my understanding that my ‘94 f350 (7.3 IDI) with an e40d has the parking brake attached to the transmission. So, since I’m looking to swap to a ZF5 how would I go about installing a new parking brake? I’ve never had a parking brake that...
  12. ComatoseLlama

    Rustproofing opinions? Converter vs wire wheel

    I'm planning out my half restoration of my truck, body has a few quarter sized rust holes, and the frame has some solid surface rust. It isn't the flaky rust like most Midwestern trucks have, this one spent most it's life in Alaska. The frame is 100% solid, no holes. The pic attached is my...
  13. ComatoseLlama

    89 7.3 banks sidewinder turbo kit upgrades?

    Got my 89 f350 custom cclb 7.3 a few months ago and have been wondering if there are any turbo wheel upgrades for my banks kit? Website and support say it's designed for high rpm, high stress engagement. It is the old school sidewinder kit with the big aluminum intake so nothing on the banks...
  14. Kraig

    95 f350 mini leaf pack lift qurstion

    Hey guys, Has anyone put the mini leaf packs on their OBS f350? I have the u bolts, packs and spring center bolts but am wondering what else I need for the install. This is my daily driver so I need to have everythibg ready to put it all on at once. I am thinking I may need a track at drop...

Latest posts

Forum statistics

Threads
91,299
Posts
1,129,935
Members
24,109
Latest member
Lance

Members online

Total: 519 (members: 8, guests: 511)

Share this page

Top