7.3idi

  1. B

    E4od idi

    Just bought a 93 f250 7.3 idi n/a having a issue where sometimes the truck will shift on its own like normal and sometimes I have to manually shift it because it will try and start out in 3 or O/D. The O/D light never flashes any help would be awesome !
  2. 03wr250f

    How to set up a Reverse Shackle Kit

    How to set up a Reverse Shackle Kit Tools Needed Corded Drill, as it will put up with the abuse of lots of drilling and a reamer 7/8’’ reamer. Trust me it’s worth it to spend the money on it versus buying a harbor freight step bit. Air hammer and chisel bit Plumb bob, in a pinch a piece...
    • 03wr250f
    • Thread
    • 6.9idi 7.3idi babe babetheblueox dana60 idi rsk solid axle sparkles turbodiesel
    • Replies: 3
    • Forum: IDI Tech Article
  3. S

    Special designed WVO-Glow-Plugs for 7.3idi - available soon

    Relating to my thread here: https://www.oilburners.net/threads/7-3idi-wvo-and-glow-plugs.91408/ During March/April I will expect a shipment of especially designed glow plugs for the 7.3idi engines. - I have to order this weekend to make the schedule happen. Idea is to bring the starting...
  4. Minty Ferd

    Twin Turbo setup 7.3idi

    I'm thinking about doing a twin turbo set up on my 7.3 idi. As of now I have true duals that run to the back of the cab and go up though the flatbed. They are attached to the headache rack and are capped with a rain cap. I have this old rusted out toolbox right next to were the two pipes turn...
  5. Thelebowski

    V-Belt A/C bracket for 92 7.3 idi

    Howdy yall, im new here and i see this place stays pretty active, which is awesome. Most threads i’ve searched have been decades old. anyhow, i got a 92 f250 with the 7.3 idi non turbo. Tryna install ac, i got the condenser, evaporator, and a v-belt compressor/clutch ready to go. Everything...
  6. P

    Timing Gear cover plate gasket, to use or not to use.

    Recently got a 86 f350 with a 7.3 swap and needless to say the last owner knew nothing about these engines (doubled up crush washers in injector bores, 2 teeth off timing gears) so I'm retiming it and installing new front main seal, IP and injectors. The question is do I absolutely need the...
  7. 1

    Selling 1988 F250 7.3 IDI in North Carolina for $2,000 OBO

    1988 Ford F-250 with a 7.3 Liter IDI diesel engine and a 4 speed with overdrive manual transmission. This is a running project vehicle that is not currently licensed. My plan was to fix it up as a weekend hunting camping truck to go out with my sons during the season. However, plans have changed...
  8. Dregs Garage

    Great website new Guys

    I came across this site and found a lot of general information I think a lot of you already know but with new guys on the forums all the time this is a great site for a quick read, or look up of info. http://www.dieselhub.com/idi/idi.html Enjoy!
  9. thevanbulance

    Cold advance/high idle drop in power when switching to low idle

    Hi guys, Lately I've been noticing my 1990 7.3idi is exhibiting a strange behavior when switching over from high to low idle. Here's the proceedure leading up to and including the symptom: 1.) Cold start the engine and the high idle/cold advance appears to be working normally with my engine...
  10. C

    Which Rear Axle Ratio? (31ft MH, 7.3idi turbo, Allison 1000)

    Hello, I'm slowly coming along with my project, but in the near future I have to decide which rear axle ratio will be installed. My Setup: 31ft Airstream 310 Motorhome Max. 14500lb., Dana 70HD Axle, 7.3idi with Hypermaxx turbo. (Rebuilt is planned, I will consult the forum, right now the plan...

Latest posts

Forum statistics

Threads
91,284
Posts
1,129,794
Members
24,099
Latest member
IDIBronco86

Members online

Total: 771 (members: 6, guests: 765)

Share this page

Top