Search results

  1. Ct96

    Fuel tank switch seems to have quit working.

    The switch correctly changes the gas gauge, so it reads full on my front tank (accurate) and half on my rear tank (accurate), but I guess the motor it's supposed to be activating isn't doing anything... What is the part I need for it and how difficult of a job? Thanks guys.
  2. Ct96

    Stp 15w40

    They got this at my parts store for 60 bucks / 5 gallons. Quite a bit cheaper than rotella t4. Reviews seem alright, anybody run this stuff?
  3. Ct96

    Blinkers + Hazards quit working

    well, ****. I hope I get lucky hahaha
  4. Ct96

    Blinkers + Hazards quit working

    Okay I replaced this flasher and my blinkers still aren't doing anything. I found what I believe is the correct part on Amazon - https://www.amazon.com/dp/B078BNG3HY/ref=cm_sw_r_apan_glt_i_4GZ6ZA9Q3WCZBTZAM440?_encoding=UTF8&psc=1 Does anybody happen to know if this is the right guy? I'm...
  5. Ct96

    Blinkers + Hazards quit working

    Hey all, just wanna start by saying thankyou for the help on my last issue. My glow plugs are manually controlled now and I'm very pleased. Anyways, maybe something I did while swapping that (I didn't disconnect the batteries and my ratchet sparked a few times..), or just by chance, my blinkers...
  6. Ct96

    unknown wires towards front of engine, off of glow plug loom?

    Damn!!! I guess I will have to leave that plastic connector hooked up. Thankyou, now I know what to look for when I get the glow plugs all buttoned up. Hopefully I didn't do any damage
  7. Ct96

    unknown wires towards front of engine, off of glow plug loom?

    Thankyou and I apologize, I am not very YouTube savvy. Here is the new link.
  8. Ct96

    unknown wires towards front of engine, off of glow plug loom?

    Hey, thankyou for taking a look. The reason I want to remove the controller is I have a new White Rodgers controller which i've heard on this forum a few times is somewhat of a more stout upgrade. The reason i'm so worried about these wires is that I tugged on them pretty good, and the big...
  9. Ct96

    unknown wires towards front of engine, off of glow plug loom?

    the picture with the green circles is what I don't know the purpose of. The blue circle is showing where the loom starts / is fed off of, in the engine bay fuse box Its the same loom in both pictures just different locations of it.. I already removed all of the old bullet connectors off the...
  10. Ct96

    unknown wires towards front of engine, off of glow plug loom?

    I was trying to do the manual glow plug conversion and it said to remove the old glow plug harness + controller, so I unplugged it from the engine fuse box (big hefty plastic connector) and started to yoink it out, but it was stuck because of two wires that were still connected to the engine...
  11. Ct96

    New rims on a dually

    I wanna get some rims for the dually, which is on stock rims. I found some online that are cheap and will look good I think. They are 16x6, specifically made for a dually truck and it says they fit my year/model. Just wondering if I can keep my two stock inner rear rims? The full set only...
  12. Ct96

    Big gash near oil pan? Or in oil pan?

    Thanks all, I can rest easy then !!
  13. Ct96

    Big gash near oil pan? Or in oil pan?

    It's stick, that would make sense. It does drive fine, I'll just ignore it then. I just wanted to make sure I wasn't dumping lubricant out of that hole. Transmission fluid or oil or otherwise. The truck has 140k miles so someone probably has done the clutch at some point. Thankyou again!!
  14. Ct96

    Big gash near oil pan? Or in oil pan?

    I feel like a dumbass. So it's supposed to be open like that? Thank you for your reply. The leak isn't bad at all so I'll just ignore that.
  15. Ct96

    Big gash near oil pan? Or in oil pan?

    I attached photos. Went to change my oil and noticed this big gash near my oil pan. What the heck?!? It looks like it popped from pressure. This is definitely not normal right??? How bad is it to keep driving the truck for now? (It's my only work truck) 1992 7.3 idi in a Ford f350 dually 2 door...

Latest posts

Forum statistics

Threads
91,301
Posts
1,129,947
Members
24,110
Latest member
Lance

Members online

Top