Search results

  1. Mr_B

    Return Lines Leaking

    I did a search on this and found a few things but nothing answering my exact question... The truck recieved new injectors and return line kit about 1.5 years ago and has run fine ever since. However, a few months ago it started running a little rough and I replaced the fuel filter to no...
  2. Mr_B

    Dana 70 front

    So I have been working for a lady out in the country and she has some stuff around the property... Well, just so happens that there is a dana 70 front end I found and she said I'm more than welcome to have it but all the information on the forums are usually about d60 fronts. The axle...
  3. Mr_B

    Hummin the Devil's tune...

    First I just want to thank you guys for helping me with the information about getting my truck running again. ;Sweet Really helps to know those torque numbers and proper procedure. Anyways, it only turned out that one glow plug came out with out the tip so I didn't pull the other head...
  4. Mr_B

    rocker arms

    Ok so I've got the heads off... After I put them back on do you torque the nuts that hold the rocker arms to a sqecified torque and if so what is that? What I have always done on the small block chevys is turn the motor until (for each piston) the exhaust valve just starts to open and then...
  5. Mr_B

    Glow plug tip broke

    So I started to pull out the old plugs and most were ok, but of course one came out with out a tip :mad: I suppose that means I need to pull the head? I haven't started it yet and don't intend too. Any suggestions? i.e. what kind of head gaskets and while I'm at it what else might be worth...
  6. Mr_B

    Glow plugs

    I know everyone says to get beru plugs instead of champion or autolite and other and I know the reasons, my question is were do you get the beru glow plugs? Is that a stealership only item?:dunno
  7. Mr_B

    Front end

    I have the two wheel drive f250 in my 86' and it is really chewing up my tires on the out side edge cookoo You would think that over time the springs would sack and the tires would ware on the inside of the tire... Anyways, I've replaced all pitman arms, tie rod ends (basically everything from...
  8. Mr_B

    7.8L?

    I have the 6.9l in my turck as the sig says but I was wondering if anyone knew anything about the 7.8l ford diesel.... I know absolutely nothing except that it is in a 1989 L-8000 dump truck with a 5 speed (zf5???). I'm tring to figure out if it was any good, things to look out for, etc...
  9. Mr_B

    Shop Manual

    Was wondering if anyone knew where I could get an "official" shop manual for my 86' F250? I'm trying to find the ones like I have for an s10 I own. These ARE the manuals they use at the factory dealerships. I suppose more than anything is I'm wanting legitimate information on engine specs...

Latest posts

Forum statistics

Threads
91,387
Posts
1,131,642
Members
24,184
Latest member
Bigal093

Members online

Top