Search results

  1. Trevtron

    Engine has a new ticking sound at idle

    I spend a lot of time reading on here, best resource out there and great bunch of people on here
  2. Trevtron

    Engine has a new ticking sound at idle

    Thanks, I just have a sensitive ear and got curious as to what that new noise might be caused by.
  3. Trevtron

    Engine has a new ticking sound at idle

    Thanks, Tomorrow I'll have my wife work the throttle and I'll see what she does. That sound only happened today after it was warmed up and was stopped at a light, and never noticed anything different under acceleration. Only noise in my cab is the occasional CB chatter, I don't use my radio...
  4. Trevtron

    Engine has a new ticking sound at idle

    No power loss or oil consumption, this new ticking noise at idle started today. Anybody recognize that sound? Not overly worried, just trying to see if anybody else recognizes it. Seems to be from the front passenger side, and isn't noticeable at higher rpms. So probably isn't a pulley...
  5. Trevtron

    So what did you do with your truck today?

    Finally have the timing where the mileage, engine sound and smoke should be. Put fresh transmission fluid into the transfer case and drained and pumped fresh 80w-90 into the 4 speed (T19) Greased hinges and pedal hinge points, lubricated all the accessible cables (heater, e-brake line,throttle...
  6. Trevtron

    The Texas Fall IDI Meet

    I couldn't make it either, but anybody in the Katy area who wants to meet should pm me. It's great that the IDI meet went well!
  7. Trevtron

    The Texas Fall IDI Meet

    Was going to bring my family and camp, any good places to set up a tent out that way?
  8. Trevtron

    IDI MPG

    I'm getting 15mpg on mine, mostly city type driving.
  9. Trevtron

    The Texas Fall IDI Meet

    I'll verify that I can make it and let y'all know, sounds like a good time.
  10. Trevtron

    So what did you do with your truck today?

    Great to see the old IDIs going strong! Last night I pulled the lift pump on my 83 to address an oil leak problem from the gasket, I will never again try and do the lift pump job from the bottom side of the motor...I'd advise anybody looking to do their lift pump to pull the alternator and...
  11. Trevtron

    So what did you do with your truck today?

    Installed a new slave cylinder on the 83 F250, job went well and didn't involve to much cussing or bleeding this time. Also wanted to ask anyone who's been around these trucks a while if the idle sounds correct,(Dad had one for most of my childhood but it's been a while since I've been...
  12. Trevtron

    new Diesel RX GP Controller

    Definitely, she had sat for a few years so had to do the front tank, lift pump, injection pump, injectors, belts/hoses and brakes. An ounce of prevention beats a pound of cure! For those of you who like diesel start up videos here is one from today...
  13. Trevtron

    new Diesel RX GP Controller

    Just installed new Motorcraft glow plugs and and a Dieselrx GP Controller. Much faster and smoother starts now, I was surprised at what a dramatic difference that made.
  14. Trevtron

    The Official "Show Us Your Ride" pictures of member's trucks thread.

    Nice trucks!! My 83 still needs the timing advanced a bit, but she's running strong. Just got all new brakes and wouldn't mind a road trip to the Texas IDI Meet, would be great to see all the ol diesels and meet some new people
  15. Trevtron

    The Official "Show Us Your Ride" pictures of member's trucks thread.

    Nice looking rides!!! My granddad had passed and grandma wanted me to have his truck. It's an 83 and is relatively solid for it's age. New water separator, fuel tank, lift pump, injection pump, injectors so far. Next is the auxiliary tank, selector switch and some fresh brakes. She runs...
  16. Trevtron

    Glad to be on here

    Live in Katy, TX and drive an 83 F-250 w/ the 6.9, she has low miles and plan on keeping her on the road indefinitely. Been reading threads on this forum for a while now and got tired of not being able to post and see people's attachments, looking forward to being on here more.

Forum statistics

Threads
93,001
Posts
1,155,992
Members
26,589
Latest member
tke395

Members online

Top